Search results

  1. P

    How fast have you gotten your sailboat?

    I took my 1974 17' oday out yesterday and with my 2hp honda motor maybe 7/8 kts. ZERO without the motor since there was no wind whatsoever. Going again tomorrow since there is supposed to be some wind.
  2. P

    Not peeing tried trouble shooting

    Remove lu and put it in a bucket of water make sure water level is high. Attach drive shaft to a drill and run. You should see water come up and out of the small tube couple of inches. Previous owner may have run the motor with a broken impeller pushing pieces up into the tube or motor. Assume...
  3. P

    1982 Mercury 9.8 Coolant Passage Blockage

    EBay is LOADED with parts. Just keep your eyes open for them
  4. P

    1982 Mercury 9.8 Coolant Passage Blockage

    You never know what the previous owner did to the motor. Assume the worst like the water pump impeller broke into pieces and got shoved into the block.
  5. P

    1967 6hp 600

    I would NEVER run a motor that is not peeing for more than 5 seconds. Any more than that and the OLD impeller could explode pushing pieces into the block causing blockage. Just replace the water pump impeller and run it. Make sure the water level is high on the lower unit.
  6. P

    2009 mercury 4 stroke bogging sometimes

    How old is the fuel pump? You can crack it open and see the condition of the diaphragm.
  7. P

    1982 15HP Evinrude dies around 2 min during fast idle

    Sounds like the vent on the tank is closed. Just remove the cap from tank and see if that helps.
  8. P

    1996 Evinrude 88 - Drive Shaft Seal Should never leak under pressure / vacuum - right?

    Is the drive shaft PITTED right at the seal?
  9. P

    Mariner 8hp w Marathon only firing bottom spark plug

    Sailboat?? Been in saltwater? I would check EVERY electrical connection before anything else. Salt destroys everything. Pulling the FLYWHEEL requires a 3 bolt puller. Buy it at harbor freight.
  10. P

    85 Mariner 75 HP

    If it's a 2 stroke I would not shoot starter fluid in the carbs. So many things it could be but you could unhook the fuel pump hose and crank it to see if any fuel is coming out. Cover the hose with a towel.
  11. P

    1979 Mercury 85 HP model 850

    Look on ebay
  12. P

    Water Flow

    Pull lower unit and attack a drill to the drive shaft put in bucket turn on drill water should bubble up and out of pump. Make sure lu is deep in the water when testing. Has this motor been in salt water? Good luck if it has. Few people flush the salt out correctly.
  13. P

    1981 7.5 merc surging idle

    Minimum info but....95% of the problems I see on motors is dirty dirty dirty or worn rubber components. Clean the carb. Replace the diaphgrams etc.
  14. P

    Merc 39 shifting

    Yea something is not right here. I can't seem to get the rod to align properly with it on the bench. Should the rod slip into position EASY or is it hard to get it seated? I think I will have to disassemble the gear box to realign everything. Is there any kind of instructions on disassembly and...
  15. P

    Merc 9.8 110 questions

    Looks a lot like my 1968 merc 3.9. I first removed the split pin from the choke lever and remove lever. Cut both fuel hose (replace them) I used generic hose. Remove two small screws holding the filter housing lift out slowly don't lose anything. Unscrew the two small bolts holding the inlet...
  16. P

    Merc 39 shifting

    Changed the vertical shift rod SEAL but after I reassembled everything it will not shift suggesting I did not align the shift shaft correctly. I'll pull it apart again to inspect. Any special instructions on how to realign those parts? I think it's a 1968 sn 1912366
  17. P

    1982 Mercury 9.8 Coolant Passage Blockage

    Was their ANY rust on that motor? If so it's been in salt water. If the guy you bought it from says never in salt water......most likely been in salt water. Remove l.u. turn upside down shoot in pb blaster in the copper tube and flush hole and let sit. Salt water motors "to me" is good for one...
  18. P

    TSB' S where?

    Where can we go to find outboard tsb's based on our serial number?
  19. P

    My 1997 150hp rebuild

    So is the " advance module" the same as the idle speed control box?
  20. P

    1997 Sears Gamefisher 9.9 2 stroke won’t start

    I just recently sold a 1974 sears 7.5hp. I had to clean the carb since it was full of crud. Also this one had one of those extra tall impeller. Was running great when I sold it.
Top