Search results

  1. C

    Overheating 502

    Short video and pic of T Stat Is it a bad idea to run with TStat removed to see if it still overheats?
  2. C

    Overheating 502

    Motor number ol605421 Will work on Tstat today Thank you!
  3. C

    Overheating 502

    I have videos but apparently they are too large a file. Winter on a trailer in Michigan. I am very confident I winterized the block and manifolds adequately by pulling blue plugs and inserting wire up into it so all water would drain out before reinstalling the blue plugs.
  4. C

    Overheating 502

    2000 502 Mag MPI Bravo 3 drives with captain call exhaust. I messed up and didn't notice that I failed to reconnect the hose from the I/O lake water intake hose to the impeller last fall. Launched a few days ago and since it wasn't getting any water I smoked the impeller. Since it was bone dry...
  5. C

    Winterizing questions

    Sorry, boat is used in a fresh water lake, no salt. No antifreeze or heat exchanger anywhere on this engine.
  6. C

    Winterizing questions

    Getting ready to winterize a new to me boat this year. Freshwater Twin 502 Mag MPI in a 2000 Formula 400 ss. First pics shows raw water impeller to the left for drawing water from the B3 drives correct? First pics also shows a sea strainer at the bottom of the pic that I am confused about its...
  7. C

    How to get Navionics on a large screen at the Helm

    Bought a 2000 Formula boat that comes with an old Ray Marine plotter that needs to be replaced. I think the Navionics phone app is amazing in detail and accuracy. I suspect I could buy a slightly used tablet and somehow mount it where the Ray Marine unit is now. I would do this instead of...
  8. C

    Kohler generator cylinders keep hydro locking

    Not sure what Dieseling is but will post a short video later today of it shutting down. Thanks
  9. C

    Kohler generator cylinders keep hydro locking

    I didn't winterize it. Bought it this spring (2000 Formula 400ss)
  10. C

    Kohler generator cylinders keep hydro locking

    I couldn’t find a generator section so admin please move if needed. After two separate trips I have gone to start my genny only to find its cylinders flooded in water(luckily fresh water). I removed plugs, cranked over until water gone and got it running again. The first time this happed I...
  11. C

    Solenoid location

    New to me 2000 Formula 400 SS with twin Mag MPI 502 Port engine always starts but struggles to turn over. At first I thought it might be the battery but I have ruled that out by removing them and bench testing at auto store and using the emergency crossover switch that uses both starter...
  12. C

    V Drive trans oil analysis 1999 380 DA

    Where all 380 DA Sea Ray 1999 V drives made by ZF? Trying to figure out my worst case scenario if I have to rebuild or replace the V drives, but neither I or the seller know what make and model they are.
  13. C

    V Drive trans oil analysis 1999 380 DA

    The boat I am interested in had a prior buyer back out because the trans oil analysis says something about metal. I don't know exactly what it says, we are trying to get a copy from the survey. I expected to find a lot of posts about this but I can't find anything. What is problematic and what...
  14. C

    Canvass issue

    I’m wondering if anybody has successfully been able to cost effectively restore the underside of canvass that has what I assume is a factory vinyl coating that is peeling off. Mine is from a 1998 SeaRay. I was thinking of systematically peeling all of it off and applying with a paint roller...
  15. C

    Norcold fridge troubleshooting

    1998 SeaRay 290 DA Norcold DE-351D Trying to determine if my dead fridge issue is as simple as the thermostat control located inside the fridge. I think I need to close 3 circuits: The Thermistor The On/Off switch The temp dial Thermistor is easy, other 2 are my concern. Which combination...
  16. C

    Exhaust manifold not draining when probed with coat hanger?

    1999 Sea Ray 290 DA with twin 5.7 freshwater cooled blocks and manifolds. Tried to winterize today but starboard side exhaust manifold on starboard engine didn't drain any water when I pulled the blue plug out. I am perplexed as I have done this many times with various engines and always had...
  17. C

    Replacing a Bennett trim tab

    Getting ready to replace the port side trim tab soon. Any advise on doing so while minimizing air in the hydraulic line that leads to the tab?
  18. C

    Fuel gage issue

    2001 Stingray 200MS Gage shows empty when I know its at least half full. Gage does move slightly up when key is turned to ON, so its not completely dead. Where should I start? Or can someone point me to an old thread that gets into it, I had no luck with a search. Also, I have other...
Top