Search results

  1. C

    Rust, generally how to clean and best spray to keep it from rusting?

    Is the winch is galvanized? If so, use some "Cold galvanizing" spray paint.
  2. C

    Upholstery East Cost PA, NJ, NY, DE

    Custom upholstery is pricey. You might look at some stock items from Wise or others and buy as much of it as you can. Then have the pieces that do not exist as manufactured, custom made.
  3. C

    No spark on half the motor!

    Usually located near shift cable. You might check the parts diagrams at crowleymarine or other site, to see if you have a shift assist switch and where it is located.
  4. C

    mercury 225 idle rich carbureted

    OK, Other causes of flooding are carb floats on one side set too high or inlet needles bad on one side of engine? Idle mixture set wrong on one side of engine? Weak spark at idle on one side of engine (not sure if this is possible)? You might check the thermostats. Maybe one is stuck causing...
  5. C

    mercury 225 idle rich carbureted

    White could mean overheat. Brown is usually a good sign. Does that motor have a pulse driven fuel pump? If so, the fuel pump diaphragm can leak putting raw fuel into the crankcase at idle. This fuel usually burns off at high RPM, if you can achieve high RPM.
  6. C

    Bought a boat yesterday

    Gee, give it a sniff if you don't believe.
  7. C

    Water test on 115 HO etec

    Both motors are the same generation. Not sure about gearcase ratio but would not expect it to change. You might check it out. I would expect the props to swap over with the same performance. Since you went to a 2"pitch less prop, I would expect about a 400RPM increase at WOT. If the old...
  8. C

    charging help

    Set a voltmeter to AC voltage, start the engine on a flusher and see if any AC voltage is getting to the battery. If so, the diodes in at least one of the voltage regulators are bad. Just so you know, neither of the VRs power the ignition. They both serve to charge the battery.
  9. C

    Trim issue 1995 115 hp

    Tape 'em up or get some insulating shrink tube from home despot or a HW store to insulate them. On the other hand, if you don't want to fix the bare wires, you need to replace the PTT motor.
  10. C

    Trim issue 1995 115 hp

    Jumper the PTT motor and see if it is still good. That is, if 2 wire PTT motor ground one PTT motor lead and provide power to the other lead. If you have the three-wire PTT motor, check the ground on the black wire. Now apply power to either the green or blue wire and see if PTT motor turns...
  11. C

    All gauges went out. What to look for?

    Still look for a bad ground. The gauges may be grounding thru the nav lights circuit, and when you apply power, the ground is lost.
  12. C

    Bought a boat yesterday

    Fuel tank vent
  13. C

    charging help

    That motor and most others with charging systems are not made to be run with batteries disconnected. Disconnecting the battery will damage the new VRs you installed. I also do not know what effect it has on the EFI system. Why would you intentionally disconnect the batteries?
  14. C

    ACR with Inverter Question

    Gee, I think you are asking a different question now. Running mechanical devices at 100% capacity is likely not good for any of them. i.e. Run your car at 100% of power for an hour and see what happens. Are you really going to use 165Amps of power for an extended time? If so, you might get a...
  15. C

    Starting problem

    Your radio, depth finder and lights may be directly connected to the battery and may work w/o any power to the ign switch.. Your ign key is likely fused at the motor. Check that fuse first. Do your gauges work? They are usually powered by the ign key. If fuse is good and she doesn't crank...
  16. C

    ACR with Inverter Question

    OK, so if your car battery goes dead, and you jump the car to get her started. Would you not expect the alternator to charge at or near max? Now if the alternator is shorted to ground, the diodes in the voltage regulator will likely be damaged, but not the alternator windings.
  17. C

    1978 Lund Deep V Hull, bow raising up dangerously high

    Gee, a lot of weight in the stern is a relative term. What is the weight of the boat, say 150# or less? The motor is 60-80#, battery is 40# and fuel is 50#. So gas, fuel and motor likely outweigh the boat, hence the stern being a lot lower in the water, while it is moored. Move fuel and...
  18. C

    ACR with Inverter Question

    Gee, alternators charge max all the time w/o burning out. What makes you think your's will burn out?
  19. C

    Distributor harness 1976 mercury 115

    CDI Electronics has a test on their website that tests everything in the ign system, except the distributor trigger. You might run it so you know your wiring, coil and switchbox are good.
  20. C

    Add a kill switch, Johnson 50hp, 1996.

    This kind of ign switch came installed in the dashboard of my 1998 boat and 150HP Johnson outboard. The kill switch is built into it. 175974 5005801 Ignition Switch & Key Assembly with Safety Lanyard, Fits for OMC Johnson Evinrude 40-200HP Outboard Motor
Top