Search results

  1. C

    Tilt trim making weird noise.

    rotax ? https://www.marineenginedigest.com/profiles/evinrude/etec.htm
  2. C

    25hp Evinrude

    in fact.. all the usual stuff.. compression has suggested, Carbs, try pressure test on the GC, GC water check and new oil ! , reseal GC if need be, , grease all nipples till new grease oozes out , new plugs, etc...including any filters , tank pick-up, new hose maybe and bring a friend...
  3. C

    1982 Johnson 50 Sea Horse - Constant Beep While Accelerating

    click on the small enveloppe on top corner for a private message . visit utubes lots of good videos on yours or similar models usually
  4. C

    1982 Johnson 50 Sea Horse - Constant Beep While Accelerating

    sure sounds like op needs to read up on OB maintenance which is the plan I guess. btw low oil in the gear case won't give you a buzzer if that is what was suspected. How would I verify if there is a faulty ground wire? likelkely no need to check... if it was touching the engine frame...
  5. C

    1982 Johnson 50 Sea Horse - Constant Beep While Accelerating

    peeing just tells you the impeller is pushing water up the engine and out.. the cyl jacket cooling itself is thermostat controlled so any malfunction would not stop the peeing ....yet an overheat condition could still exist . (BTW is this a salt or fresh water engine?) since this a new to...
  6. C

    Tell tale or bubbler what’s normal w/o a thermostat

    I think you need to determine if the engine runs hot or not ... qualifying the volume of water out of the " bubbler" isn't all that improtant if it does spit out water .& . if the water is not boiling hot (should be luke warm) most of the water goes out the prop anyway. a typical samll ob...
  7. C

    Help! 2000 Johnson 90hp V4 overheating on one side only...

    if passages are clogged with minerals any chance a good bucket run with "Salt Away" would help ? https://www.saltaway.com/concentrate-kit-sa32m see utubes on desalting overheating engines
  8. C

    1989 Johnson 50hp fuel pump fittings

    cheap or not 2 port pumps seems to be available on Amazon .. drilling and caping a 3 port pumps semms needlessly complex ... tried a dealer for a pump...
  9. C

    AC voltage 1990 evenrude

    just make certain the 25vac is reaching it...otherwise no output !!
  10. C

    1960 Evinrude 5.5 fisherman outboard

    if the carb float is ok the carb may just need a good cleaning.. points can sometimes just be polished (burnished & acetone washed ) and still work fine ... even better than newer points manufactured out of specs !! stick with OEM stuff. some chinesse kits have been known to have "melting...
  11. C

    Stator/CDI alternative test

    best not to revive old posts .... post is 6 years old so it it fixed or sold ! as to the stator it is just wire coils energized by the FW so coils can be bad in few ways ... open... grounded shorted out of specs all of which will produce no or low ac volts at a given RPM...
  12. C

    1960 Evinrude 5.5 fisherman outboard

    first thing is to look at on line sites like Craiglist EBAY etc... visit boat shops..(some accomodate clients wishing to sell stuff) try to stick with freshwater engines around here they go from $100-200 CDN $ check compression before you buy and it turns over. a run test is...
  13. C

    Engine warning light Evinrude Ficht RAM 2002/2003

    you should not have frozen water if stored properly & vertically check manual for code 22-27 do appropriate voltage readings with VOM on the 12 volt distribution .I doubt high temps influenced the alarm code 43 may indicate a water problem..did it pump water ok before ?? just my...
  14. C

    Spark or No Spark?

    the motor won’t run, but will fire on starting fluid…..not on fuel mixture….sprayed into carb throats. so why doesn't fuel reach the cylinders if it fires up on starting fluid.. I read lots of electrical.. .work... what about carb work ??? are they full of fuel mix ??
  15. C

    Pre-emptive repair/maintenance to do on a used Evinrude 9.9?

    here is what a $50 ..... 1966 9.5 looks like when given TLC.... your looks like an abused fatherless child
  16. C

    Pre-emptive repair/maintenance to do on a used Evinrude 9.9?

    looks beat up to me the innards are probabaly beat up also ....
  17. C

    Engine warning light Evinrude Ficht RAM 2002/2003

    Glad you found it.... hopefully your on your way fishing :) thanks for your feedback yet the mystery..... why was black ground missing but it is accademic now. :)
  18. C

    Old motors DEMAND to be retired when they are 65 years old..

    The Vega was quickly coined the "Déga" up here in Québec. :) Transalation: Déga: total mess, a desaster, a pile of s... ok back to OBs
  19. C

    Engine warning light Evinrude Ficht RAM 2002/2003

    see manual on 20002-6 FICHT sect 3.41.. + my understanding is that he CPS is a AC signal generator and would normally be without DC voltage . it has OHMS resistance to check and if your engine does start.... it is working otherwise the EMM would interrupt the start process. as to ats...
  20. C

    Help! 2000 Johnson 90hp V4 overheating on one side only...

    time to dig in...if ph removal not your option try to fish some heavy mono line in the cavities try air pressure , try the cyl head removal to get a better look inside the jackets.. etc...
Top