AC voltage 1990 evenrude

[Chuck4741444]

I bought a 1990 evenrude 150.
I got the motor running,
Im checking everything out,
Running, I get 9.0 volts ac on ( y1, ) and 2.4 volts ac on( y2 )
Together I get 25 volts ac
I have 3 Stater plates to compare against each other for resistance,
One on a running motor, one is extra parts and the 3 is a new one for my mower.
They all comes between 6.3 and 7.5
I don't know how acute this Meyer is. But I get typical reading.
I'm not getting DC voltage, but it produces enough voltage to run with battery disconnect.
I think the Stater is going out. But I would like a second opinion
All test are at 1000 rpm.
I have a foot pedal, so I can't raise rpms and test at the same time.
I'm look for options before I start buying parts I don't need.
Thanks.

 

[saltchuckmatt]

Experts will come along but running without the battery connected ruins the rectifier.....so I'm told.

Your outboard doesn't need a battery to run though and the charge coil and the ignition stuff are totally separate.

 

[Faztbullet]

25VAC from stator is about right. You clip off top of sine wave and 12.5DC is output on red wire from rectifier.

 

[Chuck4741444]

I'm not getting getting anything from the read wire, I guess my voltage regulator is bad?

 

[Crosbyman]

just make certain the 25vac is reaching it...otherwise no output !!

 

[Faztbullet]

Make sure the purple wire at rectifier has 12v with key on or rectifier will not turn on

 

[Chuck4741444]

Make sure the purple wire at rectifier has 12v with key on or rectifier will not turn on

Thanks, I'll check that, I had trouble with tilt and trim from the remote switch, the red plug was corroded with green stuff. I clen and go t&t working, If the purple wire runs through the red plug, i could test it there? I have manuals for my newer 96 johnson, iim flipping this motor, is the wiring color code the same?
Thanks guys.