Search results

  1. HighTrim

    milky lube

    Re: milky lube The gaskets for the drain and vent screw are often over looked and are the number 1 spot for a water intusion. I hope you replaced them when you serviced the lu?? Remember the water will sit at the bottom of the gearcase, so when you check the oil, the water will come out...
  2. HighTrim

    carb rebuild

    Re: carb rebuild That is a good video to watch when doing a carb for your first time, I always post it myself. However, more often than not when the jets are not removed, the owner often wonders why the outboard still does not perform as it should. Those jets are often overlooked, yet should...
  3. HighTrim

    69' 25hp Evinrude Flush

    Re: 69' 25hp Evinrude Flush These buckets are always easy as well.
  4. HighTrim

    HELP! Another "What Year Johnson" Question, No Model Plate

    Re: HELP! Another "What Year Johnson" Question, No Model Plate I dont believe it is a 78 or 79 1978 9.9 1979 9.9
  5. HighTrim

    johnson 6 H.P. throttle problem

    Re: johnson 6 H.P. throttle problem I agree. Try drawing a line across the hub and prop, or use the cotter pin as a center line. Run the motor in the water until you hear it "rev". Pull the motor and inspect the line. If it is no longer lined up, your hub is spun, and you need to get it re...
  6. HighTrim

    '71 Evinrude 85HP Buy Inspection; Part II (long)

    Re: '71 Evinrude 85HP Buy Inspection; Part II (long) Look for the model number. It should be located on the port side stern bracket, located here. If it has been painted or removed, you will need to find the welch plug. It should be on the top rear of the motor, and will look like this...
  7. HighTrim

    1988 Johnson 88HP trim/tilt connection

    Re: 1988 Johnson 88HP trim/tilt connection Is this the wiring set up on the new boat?
  8. HighTrim

    Lower Unit Leak Down

    Re: Lower Unit Leak Down Here are a couple examples. "http://cgi.ebay.ca/ws/eBayISAPI.dll?ViewItem&item=4610113711&ssPageName=MERCOSI_VI_ROSI_PR4_PCN_BIX_Stores&refitem=160177776035&itemcount=4&refwidgetloc=closed_view_item&refwidgettype=osi_widget"
  9. HighTrim

    Carb rebuild '76 115hp

    Re: Carb rebuild '76 115hp Compliments of FR
  10. HighTrim

    '77 Johnjon 55 cooling problem.

    Re: '77 Johnjon 55 cooling problem. Here is your t stat. Number 12 on the diagram.
  11. HighTrim

    Neon Tester...

    Hey guys. Was looking for a Stevens neon tester, M-80 or S-80. There is one on ebay, but the price is getting up over 100 bucks, is this about right? Anyone know the year ranges this tester will work for troubleshooting the ignition system, and will it work on other brands such as yamaha...
  12. HighTrim

    Got an old one...

    I picked up a South Bend Ind. Johnson Motor Co. Outboard, Model A-25 , which is a 1925-1926 2 hp. Never quite had one this old, anyone have any tips for where to start. The owner said he tried to turn the flywheel over by hand and it didn't want to co-operate, and the prop shaft will turn a...
  13. HighTrim

    Explain the 'CD' ignition system, what is 'CD'?

    Re: Explain the 'CD' ignition system, what is 'CD'? Your magneto capacitor discharge (ie CD) ignition system consists of five major components. They are the flywheel, stator and charge coil assembly located under the flywheel, timer base and sensor assembly located under flywheel, power pack...
  14. HighTrim

    What Evinrude Outboard do I have?

    Re: What Evinrude Outboard do I have? And what you need to find is the model number, not the serial number, to produce an age for the motor. This is the location that Joe was referring to, compliments of FR Also Im not 100 percent sure, but would that vintage have a welch plug, top rear of...
  15. HighTrim

    Remove shift rod part on '93 48hp

    Re: Remove shift rod part on '93 48hp Is it item # 14 and #4 that you are referring to?
  16. HighTrim

    tilt motor runs, engine won't

    Re: tilt motor runs, engine won't Is this the correct structure for it?
  17. HighTrim

    Tachometer install on 1981 75HP

    Re: Tachometer install on 1981 75HP This may help.
  18. HighTrim

    Power tilt 1988 evinrude 40hp

    Re: Power tilt 1988 evinrude 40hp Is it the tilt aid cylinder that you are talking about?
  19. HighTrim

    Need help - See Pictures

    Re: Need help - See Pictures This should help. "http://epc.brp.com/default.aspx?brands=ej&lang=e"
  20. HighTrim

    decoding OMC serial numbers to get year.

    Re: decoding OMC serial numbers to get year. This should help. "http://epc.brp.com/default.aspx?brands=ej&lang=e"
Top