Search results

  1. roscoe

    Wire rope replacement

    I was thinking to tie the cable around the wife when she was sitting on the lounger. Figured she had enough ballast to keep the cable tight. Good thing her swimsuit is green, or the grass stains would get her mad.
  2. roscoe

    ‘86 125 Force 2 cycle ran without oil

    Just walk away.
  3. roscoe

    Battery on I/O

    water will not harm a 12 volt battery system
  4. roscoe

    Can anyone help with this question

    Have the impeller and wear ring checked for tolerances, replace if needed ?????
  5. roscoe

    Wire rope replacement

    . Please share. I've had a few "hacks" running through my brain, but I'm sure they are not safe, or the easiest. Your info may help the next member.
  6. roscoe

    Surface gap plugs

    sparkplugs dot com recommended these. But they are not surface gap, and may or may not fit your motor. J11c https://www.sparkplugs.com/compareproducts Are you sure of that part number? Could it be UL17V ? UL17V appears to cross over to NGK 5526 BUHXW-1...
  7. roscoe

    Difficulty loading stick steer aluminum boat

    Are you driving it on, or pulling it on with a rope? I would start by suggesting you leave 1 foot of the bunks above water. Trailer side guides would be my 2nd suggestion. A photo of your unloaded trailer might help with some ideas.
  8. roscoe

    Where is fuel sending unit for 2003 Crownline 226?

    Not really a rookie question. And they should be willing to help any Crownline owner in an effort to keep some goodwill and brand loyalty. Hopefully they have someone available that has either personal knowledge of the specific model, or they have some records/plans, on how the boats were laid...
  9. roscoe

    25hp mercury tracker cranks but will not start

    Kill switch? is gas getting to the carb? Is gas getting to the cylinder? Do you have a good strong spark on each cylinder? Are you using the choke / primer/high idle lever? What is your starting procedure? compression readings?
  10. roscoe

    Boat goes goes forward when in reverse.

    did you recently replace the prop?
  11. roscoe

    Boat goes goes forward when in reverse.

    did you recently replace the prop?
  12. roscoe

    Where is fuel sending unit for 2003 Crownline 226?

    Welcome to iboats. Your best source for this info would be Crownline.
  13. roscoe

    Birdshot damage aluminum boat

    Welcome to iboats. Could be repaired, not easily. Could be patched if leaking is a concern. Worth it? That would be your decision. If I was worried about large amounts of water coming in, I would cover it with a thin coat of 3m 5200 and forget about it.
  14. roscoe

    Primer ball not holding pressure

    I've had several primer bulbs that needed to be held vertically, with the arrow pointing up, in order to get them to pump properly. I figure this is a sign of the times with cheaper material, check valves, and manufacturing processes, and poor design. Both my kicker and main motor run off the...
  15. roscoe

    Boats By Freedom Marine??

    1980 - 1997 Freedom Marine constructed performance boats from 1984 to 1992. Then reorganized to Apollo boats ? Before 1983, Freedom Marine operated in the United States as Mercedes Boats. Looks like 15 to 25 models, depending on the year. https://www.nadaguides.com/Boats/1984/Freedom-Marine...
  16. roscoe

    Water rushing over transom into splashwell

    http://forums.iboats.com/threads/water-splashing-over-transom.747294/
  17. roscoe

    Water splashing over transom

    Likely that the motor is mounted too low. Anti ventilation plate just above the propeller, should be a little above the bottom of the hull. See bottom red line in the diagram below. When on plane, the water coming from under the hull, should go under this plate, the top of the plate should be...
  18. roscoe

    Are there any thoughts on the best manufactured years for Lund boats?

    Except for the bad transom models from a few years back. 1999-2006 had a bunch of materials related transom issues. Genmar made Lunds used cheap plywood. Genmar sold Lund to Brunswick for the 2007 model year and the issue was taken care of by using better ply and processes. Plenty of info on...
  19. roscoe

    1999 Lund 1750 corner caps

    Finding corner caps for just about any boat, seems to be difficult. https://www.greatlakesskipper.com/lund-boat-corner-cap-bracket-stainless-steel-3-1-2-x-2-3-8-inch There are some on ebay.
  20. roscoe

    1981 pontoon boat

    Welcome to iboats. Your boat is not broken, just needs some TLC. Horn is overheat warning. If you can't verify when the water pump impeller was last changed, you need to do that. It needs to be done every few years. Change out the thermostat as well. Checking the water flow with ears on the...
Top