Ok wiring is about to be underway... I ordered one of these last night; decided on the 12 rather than 6 fuse block just in case i wanted to add stuff later down the road and heck it was only 5 dollars more.... Again the list of switches I was leaning towards: Master Power; Stereo; Nav lights; Anchor lights; Horn; Interior lights; Bilge pump; Sprayer bar; Trim switch
View attachment 104522
Found a local place that sells marine grade wiring... Now do i want AWG 14 or 12? I'm leaning towards 12 just to be safe... Its gonna be a two battery system; one cranking battery for engine only and one deep cycle for everything else... so ill need a battery switch, wiring for stereo, power cables... What type of connections will be needed? any special shrink wrap, crimpers, etc? I understand that u need to identify the total current in wires if everything was on at once to determine AWG but identifying what each part puts out (such as bow light, stern light, bilge etc) im not quite sure of. If you have already tackled this phase any suggestions would be greatly appreciated. Thanks