New Journey

[MNhunter1]

How did you mount the trolling motor on the front? Looks like you used spacers to make it level.

SHSU

When I replaced the bow supports and cover plate I beefed up the supports with a solid piece of ply. It still has a little bow to it, so I needed to add some shims to level the TM a bit, as well as allow clearance for inserting/removing the arm for the TM quick release bracket. The spacers were a combination of stainless fender washers and rubber fender washers. The bracket is through-bolted with washers and loc-nuts. Much easier mounting just the bracket rather than the entire motor, but a lot of trial and error to get the right shim/adjustments.

 

[eggs712]

Good looking rig, nice work.

 

[redneck joe]

if that 90 is running, and you are wanting to free up garage space, i might drive up for that.

 

[airshot]

Thanks for the pics...brought back lots if fond memories. I had one if those back in the 80's. Great boat...ours had a 70 hp and would do 35 mph.
Had lots of good times in that boat....