Search results

  1. V

    Evinrude 1995 115HP Adaptor plate assembly removal

    Head is removed. How do I remove the "Adaptor Plate Assembly" to replace the water tube grommet? The only thing I see are 3 bolts over a rubber assembly.
  2. V

    Evinrude 115TLEOR 1995 NO SPARK

    New battery, solenoid, power pack, stator, coils still no spark? Disconnected the black/yellow kill wire. No Spark? What else could I check that could cause a no spark situation?
  3. V

    Evinrude 115TLEOR Safety neutral switch

    Today Evinrude 115TLEOR 1995 - Can't start motor. Both Solenoid & Battery replaced. Starter tested OK. Key Switch line going to solenoid has juice. Not even a click sound. Control is in neutral position. Is there a "safety neutral switch" somewhere that I can check. A picture would be great...
  4. V

    Evinrude 115 bubble back 1995 crossflow

    How difficult is it to change the termostats. looks easy to take out but very tight quarters to get back in. Can I remove the bubble back to make more room for myself?
  5. V

    Evinrude 115HP 1995 Selenoid assy primer (0437238)

    Can a bad selenoid assy primer cause my motor to race at high RMS at startup?
  6. V

    Evinrude 1995 115 HP (115TLEOR) racing

    What can cause engine to race at high RPM's at start up? New fuel pump, new spark puug wires, carb.'s rebuilt compression in three Cyl ar 118 and one is 105. Is there anything I can do to check?
  7. V

    Evinrude 1995 115 HP (115TLEOR) High Idle

    Motor starts up at 850 to 1000 RPM's and after about 10 seconds races to 4000 RPM's. Other than than motor runs fine when put into gear at low RMS. Can I have a fuel pump issue?? Carb.'s were rebuilt, filters replaced, bulb primed. Is it looking for fuel at low RPS's for the reason its...
  8. V

    Evinrude 115HP 1995 (E115TLEOR)

    What can I do to check loss of power. Engine starts with no problem. Runs at 1000 RPM's idle smooth. AT full throttle it goes 2000 RPM MAX Carburetor rebuilt no leaks, all hoses attached, fresh gas, no gas blockage or air in lines etc. Plugs look good, new spark plug wires. Oil pump wires were...
  9. V

    Evinrude E115TLEOR 1995 Spark Plug Wire Question

    Just want to make sure that I have the correct wires connected to the spark plugs from coils. Standing on the ground & off the boat, looking forward at the back of the engine: The right & left sides of engine has upper & lower coils. The top "right side" of the coil spark plug wire is...
  10. V

    Evinrude Carburetor problem E115TLEOR

    Just rebuilt carburetors, reinstalled and when started in neutral, runs at 1000RPM?s then after 5 seconds or so, runs to 3000RPM?s. Shut engine down immediately. Tested a few times with the same result. Sometimes it even starts up at 3000RPM?s. Checked float level, checked needle for sticking...
  11. V

    Evinrude 115hp 1995 Gasket Sealant

    Engine # is E115TLEOR - 1995 - 115HP I am replacing the gasket for the cylinder head (0318358) & gasket cover plate (0318335). Just wondering if Permatex High-Temp Red RTV Silicone Gasket Maker would be the right sealant to use for both. Evinrude states to use a Gasket sealing compound. Looked...
  12. V

    1995 Evinrude 115 (115TLEOR) buble back

    Just had my engine rebuilt. Found water in the lower engine cover. Mechanic tested everything for leaks and said it was coming from the boat transom spray. Is this possible? I had this Proline 17' and motor for 15 years and never noticed this. One would think to do an overhaul the bolts would be...
Top