Search results

  1. D

    1985 Johnson 90 tilt & trim

    I have the motor up. When I push the botton to lower it, the oil pump start, retract the set of two little pistons and than the motor goes down. The problem is that the couple of two pistons don't move togheter. Retract the first at the end retract the other and then move down the motor. Is...
  2. D

    1985 Johnson 90 tilt trim

    Another question.... Is normal that the trim pistons doesn't move togheter...better when I lower the motor...the pump start and before one and after the other the pistons move. Just the two rod are retracted the motor goes down.....is normal action?
  3. D

    1985 Johnson 90 vro......too smoke

    My engine is ok now....but smoke too much. Some tip?
  4. D

    1985 Johnson 90 vro hard to starting

    Hi all my problem is that: I have a Johnson 90 hp and the engine is in good condition. The problem is the start up in cold condition. When I turn on the key and play with the enrichener the starting motor engage the flywheel and the motor run. The smoke come off the exhaust duct but the engine...
  5. D

    '85 Johnson vro start up

    Hi all just another question about my engine. In cold condition the start up is not so easy. I changed the spark plug but I don't sure that the new type are correct. Can be a spark plugs fault? After 5 minute of warm-up the start is very simple. Tanks a lot Luca Frustone
  6. D

    Johnson J90LT information

    Hi all just another question. My engine is a J90LT (90 hp V4 VRO). I have the manual instruction but I don't know which is the correct drawing (1984 or 1985). On the motor documentation is write 1985 and the VRO pump haven't any wire. When you start the motor, you hear some horn? The temperature...
  7. D

    Johnson 90 Vro V4 loss power@full throttle

    Hi I am writing from Italy and I hope to get some helpful information about my 1985 Johnson outboard. Last week while I was running with my 19 ft boat at 4500 rpm I experienced a sudden loss of power. The motor continued to run at low rpm without the possibility to increase the speed for atleast...
Top