Search results

  1. C

    Shut Off to Stop Flooding Carbs

    flooding / carb overfill is usually the result of a float/inlet valve stuck open or.... a high pressure build-up in the fuel supply.... enough to overcome the inleet needle's job of shutting off the fuel when the carb is full.... it works just like a toilet bowl valve ! did you check...
  2. C

    Can a 1984 Evinrude 6hp be upgraded to an 8hp?

    the 6hp gems ate mostly trolling motors... 8hp won't pull your skiers. it is like asking a fine swiss watch to run faster.
  3. C

    5.5 horse

    3.8 kilo... ohms (3,800 ohms) yes on the secondary HV pin to either primary primary to primary is usually 1.5 OHMS or less.
  4. C

    1976 135HP Evinrude No gas going to spark plugs/cylinder

  5. C

    Leroy'S R.I.P. ???

    would be a nice gesture but unfortunately he has not responded to several posts on the subject which does raise concerns.
  6. C

    Fuel coming out of the hose connected to the vapor pump 0433352

    oil supply clean ?? no water in the bottom ?
  7. C

    Timing Tips?

    Kilo ohms hopefully HV secondaries can range from 3-4 up to 10 Kohms primary to primary is usually less than 1.5homs if you have 4.4kohms coils lilely ok clean the points again and check the condensers. no coil wires rubbing the main shaft !! front coil to top plug!!
  8. C

    Leroy'S R.I.P. ???

    tthe question remains in twilight zone
  9. C

    1960 Evinrude 10 hp Shift Issue

    unless you buy the tool to extract the brass bushig.... threading from the top is theeasiest ... done it several limes. replace the oring and insert the brast bushing with the taper facing down. tap gently to seat the oring.. if need be polish the shift rod to remove burrs or rust...
  10. C

    Ignition issues

    very simply... just read the ohms value betwwen the B post (RED) of the switch and the S post.... (YR) you should see 0 homs (short) while you turn the key to START A push to choke (C post) key will also have 0 ohms (short) with the B+ post ONLY when pushed in . the...
  11. C

    Fuel coming out of the hose connected to the vapor pump 0433352

    problem seems to have migrated Now, it's not flooding and there's fuel in the bowl, but no run. can we presume the VST issue has been resolved ... ? findings ??? carbs are full now .......... fuel inlet needle is working.......... starts on carb cleaner but will not run...presumably not...
  12. C

    Fuel coming out of the hose connected to the vapor pump 0433352

  13. C

    Timing Tips?

    tell napa where to go.... your local bike or small motor shops can probabaly sell you 4 feet...
  14. C

    1960 Evinrude 10 hp Shift Issue

    utube is your friend... for parts try IBOATS HERE !!! on call up vintage outboard.com try your local dealer
  15. C

    Fuel coming out of the hose connected to the vapor pump 0433352

    what mdl# is your engine
  16. C

    Ignition issues

    engine mdl #??? yellow red is suppose to reach the solenoid control post to get the engine cranking .. check all wires and crimps whatever you have the key B+ Red will energize YR while turned for starting if the solenoid does not reapond trace YR and see why the...
  17. C

    Picture of fuel lines/Primer Bulb lines for J25RLEDA

    dont get soapy water sucked in !!!
  18. C

    2007 e-tec 250 lower mount corrosion

    glad to help out .... but did it work out for you ?
  19. C

    No sparking v4

    proper torque can only be met with the use of a torque wrench. to answer your question.... on small HPs engines I pretty much use my 1/4 impect driver. no problems yet . up to you
  20. C

    Gas - Oil Mixture on old Evinrudes outboards

    oil and fuel mixes ... if you are worried just shake the tank a few minutes before heading out.. it is important to mix oil in a quarter full tank and finish the fill up after never had any problems in 60 + years of boating ...
Top