Search results

  1. Alumarine

    Glastron SX 175 Gas Smell

    You should always be running your blower at idle anyway.
  2. Alumarine

    Winter Prep for So Cal

    If it's for a few months tops, and get yearly maintenance done, and don't have to worry about freezing I'd make sure the battery was charged and that's it.
  3. Alumarine

    2015 Dodge Grand caravan SE trailer wires installation failed

    If wired properly the ball shouldn't have anything to do with grounding. That might be the case if the trailer isn't wired correctly. There should be a ground from the vehicle harness connector that attaches to the ground on the trailer harness connector. When I rewire a trailer I don't even...
  4. Alumarine

    Help picking a hotter plug for Honda 2HP

    Glad you got the right plug and it's working better. Here's a link to the NGK heat range chart. https://www.ngk.com/heat-range-conversion-chart-2
  5. Alumarine

    Help picking a hotter plug for Honda 2HP

    I think CR4HSB would be a step hotter.
  6. Alumarine

    Help IDing Trailer

    With that setup and without the side guides as Scott suggested it will be difficult to keep centered if you go in too deep. As you discovered it will float side to side. Your idea of just deep enough to get the bow on the back roller is a good start.
  7. Alumarine

    Can you use 2 stoke oil in a prestolite, trim pump?

    No, don't do that. Check to see what colour it is in case someone put ATF in.
  8. Alumarine

    Fogging oil won't kill engine

    Spray a bunch in there and shut it down.
  9. Alumarine

    3.0 point gap

    On page 1B-3 of manual 13 it lists gap .016" dwell 39-45 degrees
  10. Alumarine

    oil leak on 3.0

    How did you remove the retaining nut, do have the tool?
  11. Alumarine

    oil leak on 3.0

    If it's oil and not grease then you need to pressure test the drive. You might need a new yoke seal and maybe the yoke as well it it's worn.
  12. Alumarine

    ATV and moving boat around on stone

    Did the same with a 12hp for years.
  13. Alumarine

    Sunrunner 320 classic (1990)

    Welcome. Your best bet is to get genuine volvo manuals for the motors and drives. There won't be a manual for the boat. You will have to google for info on some of the systems in the boat. Or you can ask questions here as well.
  14. Alumarine

    Main engine for trolling

    Sorry I don't have an answer for you but hopefully someone will come by with a good answer. I'm not sure why your engine builder would say not to let it idle.
  15. Alumarine

    3.0 timing

    Then it's a 3.0L and your serial number 0D445400 is probably correct. Manual 13 part no. 90-816-462
  16. Alumarine

    3.0 timing

    If that serial number applies to that motor then you need manual 13. That series came with points or electronic ignition. Did you look for a number stamped by the distributor?
  17. Alumarine

    3.0 timing

    That number isn't quite right. There should be a serial number plate with something like 0C856451 or 7 numerals If that's missing, then the engine code is stamped on the block by the distributor.
  18. Alumarine

    3.0 timing

    Do you have a serial number for that motor? If it's a newer 3.0 then points gap is .016" timing is 8 degrees BTDC at 650-700 rpm and dwell is 39-45 If it's an older 3.0 then points gap is .022" timing is 6 degrees BTDC at 650-700 rpm and dwell is 28-34. Setting the points gap will get you in...
  19. Alumarine

    Trim

    There was a good video be achris on how to do that in the stickies but I can't find it. edit - After looking through your thread I just saw you have a Bravo. Don't know if the video applies to them.
  20. Alumarine

    Trim

    Have you tried rotating the trim gauge sender to adjust the gauge reading?
Top