That's where it goes.....if you take that bracket off you can slide the water tube out, put the grommet in that hole, then slide the tube back down through it...might have to put some lube on it if it is tight. Keep it straight when putting it back in and will go right back into the pump.
Seems excessive.....not 100% sure on your engine but I believe the PH would have to come off....did on mine. Would rule out all other leak points first as this would be a last resort for sure.
If you can't see a leak inside the cowling, there is a seal on top of the water tube where the water enters the powerhead.....if it was leaking bad enough could be the cause of the overheat problem...not enough water pressure.
https://forums.iboats.com/threads/synchronizing-carbs-and-timing-on-a-75-150-chrysler-or-early-force.420505/ The late Frank A. describes idle screw adjustment beginning with step #8 in his lync n sync thread......
Glad you made it back! lol. Timing is set at WOT (in gear) only.....timing at idle will be whatever it is.....doesn't matter what the idle timing is so no need to check it. The trigger and stator problem is above my pay grade.....somebody else may have an answer.
