Recent content by juno pierrat

  1. J

    1990 Evinrude 60 fast idle lever issue

    parts 40 and 87 lock idle control lever in place so it won't move, is this stiil on your control box?
  2. J

    1982 50hp dies when throttle applied

    .30 is commonly used on many motors
  3. J

    1982 50hp dies when throttle applied

    no slow mode on 82' motors, no adjustments for temp alarm. to test, key on, there is a connection by sensor , ground it should sound alarm, in remote one wire of alarm goes to 12 volts from key switch the other to brown just like at sensor on motor
  4. J

    Need some input on 50 HP Johnson problem.

    is the armature plate under flywheel moving freely? may need cleaning and lube. if removing flywheel again , is there any dark goo under electrical items? and compression numbers are basic needed info
  5. J

    Need some input on 50 HP Johnson problem.

    i'm that guy that says" that happened to me", and i read its a new pump, anyway, turned out to be diaphragm in fuel pump leaked back into crank case. remove pump with lines still attached, pump primer bulb, if fuel come out small in back of pump, diaphragm bad, ( fuel will probably leak between...
  6. J

    '87 Johnson 50hp VRO(deleted) Idle speed issues

    raise rpm's at idle with idle adjustment screw, i think it advances timing, i agree no mixture adjustments,
  7. J

    '87 Johnson 50hp VRO(deleted) Idle speed issues

    if when motor starts to die, can you raise the rpm's with warm up lever and keep motor running. if yes, would think it maybe a weak fuel pump. even through its new. also might try raising idle rpm's, half to full turn on idle screw. as for spiting fuel, ive got a 87' 48spl and a 50 like yours...
  8. J

    '87 Johnson 50hp VRO(deleted) Idle speed issues

    did you remove core plug on top of card, 2 or 3 little holes under it could be clogged
  9. J

    new mercury 60HP fuel connection

    my installer liked no quick connections if possible, said most of service problems were related to air in fuel line, JimS123 system is a good way to go, and that merc connector leaked for me. one other comment from installer, higher HP motors with all electric fuel pumps should not have primer...
  10. J

    new mercury 60HP fuel connection

    when looking around for fuel connection for my new 50hp, settled on ones found at Walmart, after a little more research think there from Tohatsu, got some merc brand and one leaked
  11. J

    Only runs while hitting primer key

    How are the float levels set?
  12. J

    Looking in installing a regulator rectifier

    looking up parts, 110's might be from 1986 to 89
  13. J

    87 Johnson 40 HP Dies on Throttle Up and Full Throttle

    I'v got a 87' 48 and 50hp, haven't had your problems, heres a link to an online manual, PDFforless.com 1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Repair Manual P/N: 507616
  14. J

    1971 Johnson 50Hp. linkage starting point for link and sync

    what you have circled is the idle speed screw, it adjusts spark timing, turn clockwise idle should increase. the cam with mark is on right side of pic, small white roller resting on cam( and correctly adjusted on cam mark) may need changing , very common for it to loose outer layer. also just...
  15. J

    Only Running on One Cylinder

    Just a quick check, top cylinder runs the fuel pump, you list it as new, but check this, remove pump from block, hoses still attached, pump the primer bulb, does fuel come out the bac of the pump?
Top