I have a 1998 Evinrude 130 HP that is correctly running rough. It runs but backfires and stalls out. I noticed that there is a major carbon build up on the two right-side plugs. I changed the two fouled right side plugs and they fouled up in less than five minutes. The left side plug look fine...
I have a 1998 Evinrude 130 HP V4 which I believe is missing senors. The boat starts, but will not idle. It sounds like its missing firing. I believe it may have something to do with the missing senors. The senors thread into the of the top of the cylinder covers. I'm not sure which senors they...
I had to park my flats boat on the street for two days while my driveway has being resurfaced. During the night a someone hit my boat while trying to park behind it. Now the the outboard is stuck in the up position. I thought it was a problem with the trim until I noticed the Skeg Guard was bent...
My cousin changed my plugs the other day and told me a wave had gotten in to the engine compartment. The boat was running fine before the incident. However the motor will only run for 30 seconds before stalling now. The plugs are soaking wet every time I remove them after trying to crank it...
My cousin was putting in my plugs yesterday and a wave comeover the back of the boat and got into my two bottom cylinders. I took the plugs out and cracked it buts no water shot out however when I put the plugs in and took them out they were wet. Any suggestions on additives to put in to dry it...
I'm finally taking the time to rewire my 1989 1800 FS Bass Tracker. Its currently a crazy mess and many of the wires are ghetto rigged and straight scary. I was wondering if anyone had any suggestions on the type of wire gauge I should use for my accessories, what type of positive and negative...
I've been bring my flats boat back to life for the last couple of weeks and everything was going good until I lost spark to the 1995 Evinrude 130 engine. It was sitting for 3 years and it turned over right over when I first pulled it out of storage last month. It only ran for 10 seconds and...
I've smoked two batteries in the last week. Cranks fine on a fresh charge then becomes weak after a dozens starts. Not getting a lot of cranking power and smoke comes from the positive connection causing it to melt the terminal. Not sure if its a short or and issue with the starter.
