1999 Johnson V4 Looper Ticking

mlaajanen

Seaman
Joined
Apr 18, 2016
Messages
68
Hello All,


Also, I took the flywheel cover off and noticed while running the timing wheel bolt looked to have a little wobble to it. The bolt isn't loose. I turned the engine off and grabbed the timing wheel and rocked it by hand and it had some play in it, which resulted in a knocking type noise like too much play. Does this sound like the upper bearing is bad? Is it possible to change that bearing without splitting the powerhead? It looks from the drawings i found online, that it is just a cap that screws on with the bearing inside it. Any other suggestions? i'm including a link to the youtube video i took for reference about me rocking the timing wheel.

Any help is appreciated!
https://youtu.be/-6a_REZ-8oA/
Ops, if that wobbling is the crankshaft they you need to rebuild the engine I guess.
If you have been having water in the oil then I would suspect maybe some more bearings are bad and possible the cylinders
 

ReelTime2016

Cadet
Thread starter
Joined
May 19, 2016
Messages
10
I bought the boat from a guy that moved from Brunswick to near me and stopped going out because it was like a 3 hour ride to get back to familiar waters for him. The boat sat outside uncovered and i'm thinking water got in the oil that way. I only had it out once for like 20 minutes with this issue so i'm hoping it's just the upper bearings that are bad. As i said in a post before the pistons SEEMED to have no play when i pushed on them with a dowel rod on their down stroke. We will see.. Will there be evidence of what's bad when i tear it apart or will it be a lot of measuring with micrometer, etc to find whats out of whack? i'm going to begin getting it ready to pull off today.. hopefully i can at least get the power head off and ready to disassemble after i get home from work.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
You only made a crude measurement of the possible wrist pin or lower rod bearing play, pushing on the piston doesn't indicate the condition of the piston. The pistons are normally the first things to go when there's a lack of oil.
 

ReelTime2016

Cadet
Thread starter
Joined
May 19, 2016
Messages
10
Yeah i understand that. They get the most heat after all. I guess i'll know more once i get it all open.
 
Top