Search results

  1. J

    2003 Chapparal

    I’m looking for the location of the horn on a 2003 Chaparral SS 210? Thanks.
  2. J

    2001 Crownline alarm

    Do crownline boats have a delay switch for the alarm? (Doesn’t power it up for say 60 seconds) So when you turn the key on the oil sensor doesn’t automatically go off because it has no oil pressure until the engine is running?
  3. J

    2001 Crownline Alarm

    I am working on a crownline that has the alarm go off when the key is just in the on position but not running. When it’s running the alarm does not sound. It is the oil sensor causing this (if I unhook it, it stops beeping). The owner said it just started this last week. I installed a new sensor...
  4. J

    No start question

    I have a 78 cobalt with a 350. You can run it for maybe 30 minutes, or sometimes maybe 5 minutes, and once you shut it off it won’t start until it cools down. And if it starts it won’t plane out. Idles fine. I have ruled out fuel by using a jug once it starts acting up to bypass the tank and...
  5. J

    1992 ski centurion 351w

    So this year my boat started off not wanting to start. I thought I had narrowed it down to the coil. Its numbers were a little out of specs with a multimeter but not bad so I changed it. Once on the water it started cutting out like bad fuel. Got some heet, and fuel treatment hoping that would...
  6. J

    Impeller change.

    Just curious what it would cost to change the impeller on a 2008 mercury 115 4 stroke? I’m in the Midwest area.
  7. J

    Water pump kit

    I have a 1973 Johnson 65 HP and I'm trying to find a impeller kit with orings and seals, but I'm having no luck. I have found the impeller just by itself but nothing else with it. I need the seals as some of mine are looking rough. I found this kit but everywhere I see it it says that its only...
  8. J

    Trim hoses

    My friend was going to change out his trim hoses due to one leaking but before he could replace them his house was destroyed by a fire and therefore the hoses burnt up as well. He is dealing with a lot and asked me to go ahead and fix it for him. The problem is I don’t have anything to go off of...
  9. J

    79 Cobalt shift interrupter

    The shift interrupter had not been working but I was able to find and fix a wire that wasn't allowing it to ground the igntion. Now I adjusted the lower and upper shift cables to factory spec, but when going from forward to neutral it kills the engine unless u rock the shifter. Reverse to...
  10. J

    Mercruiser shift interrupter

    What kind of resistance would a good shift interrupter have? I tested it last night and with the button pressed it showed .4 ohms. Is this good or bad?
  11. J

    1979 cobalt shift question

    A friend has a 1979 cobalt mercruiser gen 1 and it will shift from neutral to in gear just fine but will not shift from in gear to neutral while it's running. Once shut off it will go into neutral fine. Not sure what would cause this?
  12. J

    2012 Axis

    Why would a hole get blown in an exhaust manifold with no kind of warning? Motor never got hot but it was like the manifold wasn't getting enough water maybe?
  13. J

    2012 Axis water in oil

    My friend has a 2012 Axis that the engine got hot in and now has water in the oil. He took to a reputable marine dealer and they tested the exhaust manifolds and said both of the them were bad and causing the water to get in the oil? I'm not saying there lying but can someone please verify this...
  14. J

    1992 Ski Centurion Falcon XP

    I just purchased a 92 ski centurion in the fall and I noticed it had 3 drain plugs. One in front of the engine and then 2 on the back, one on each side. I was just wondering the reason behind this. Thanks.
  15. J

    1988 Bravo 1 oil seal question

    I am working on my brother's 1988 bravo 1 and there was quite a bit of gear oil in the u joint bellow. My question is does the seal set behind the yoke, and if so do I remove the yoke or go in through the top?
  16. J

    Upper shift arm seal

    i am having to replace the seal that sits under the shift arm circled in yellow. Does this go in flat side up and spring side down or vice versa?
  17. J

    Bellow vent hole? Alpha one gen 1 Merc

    Water leak i have noticed water leaking from beside the water inlet on the inner side of the gimbal housing. My outdrive is the mercruiser alpha one gen 1. It has just started but I’m not sure where it is coming from. I haven’t completely ruled out the inlet tube but i don’t think that is the...
  18. J

    Wood construction

    I’m looking at a 1991 Mastercraft Maristar 210 and I’m trying to find out how much wood is in this boat? From what I can tell the stringers are glass but what about floor and transom? Any input is appreciated.
  19. J

    Impeller clearance

    I am trying to find out what the clearance should be between wear ring/impeller housing and the impeller should be. It’s a 1991 Yamaha Waverunner 3 650. I have searched the web and can’t find an answer for that particular ski. Anyone happen to know? It won’t plain out and impeller looks good...
  20. J

    Pressure in lower unit

    I have an alpha 1 gen 1 lower unit and I have noticed when I took the top vent hole screw out it to check th fluid level one day it gushed oil out and you could hear air as well. From what I have found out the internet there is a vent hole that goes through the gimbal housing at 12oclock...
Top