Search results

  1. mjf55

    1989 Yamaha 175 Prop shaft seals - how many?

    As the title reads, I have a 1989 Yamaha 175 ETXF that I am replacing the prop shaft seals. ( I already replaced the driveshaft and shift seals). Everything I read shows there are 2 seals to replace on the prop shaft. However, when I removed the first one, there seems to be a metal ring spacer...
  2. mjf55

    How to contact a moderator.

    When browsing the iBoata forum, from time to time you come up to a thread that is in the wrong forum. Often it is a request for help, and more specific help would be seen in a different forum. Current case in point...
  3. mjf55

    1998 Yamaha 2-Stroke Starting Issues

    To Add to 99Yam, if it is not clicking, measure the voltage of each small wire on the starter relay with respect to ground WHILE the key is in the start position. On wire will be 0 volts, the other 12 volt. I would guess, the black wire with the ring terminal is ground. The one with the plug...
  4. mjf55

    ship to shore power issue

    As Muc suggested, try another cable. After that, you need to do some basic trouble shooting. BE CAREFUL, YOU ARE DEALING WITH LETHAL VOLTAGES. What kind of connector do you have? Look at the attached picture. Using a DVM, on > 200 v ac setting, verify that you have 120 volts between hot...
  5. mjf55

    When in the course of boating events ...

    ... it becomes necessary for one mechanic to dissolve the corroded bonds that connect one part with another and to assume that the bolt snaps, what is a decent brand of taps to use that will not break the bank. Having a 1989 Yamaha that was used extensively in the lower Chesapeake Bay, and the...
  6. mjf55

    Rectifier wires

    So its not clicking for me yet, but getting closer. Do you have the model number of your engine? Otherwise a picture or two of the rectifier and terminal you are talking about. I did find a wiring diagram that may be close, but it is for up to an 1985 motor, 30 years old. Does this make any...
  7. mjf55

    Outboard alarm testing

    You mean the temperature switch. looks like this? Part number 0386686.
  8. mjf55

    Wiring (Mercury) - Sanity / Idiot Check Please!

    I am continuing to over think this. I have attached a wiring diagram document for mercury outboards. What you need to do is verify that the engine side harness is connected as shown in the appropriate section. Then you should be able to wire the controller to match the functions. I this does...
  9. mjf55

    Deck Section Bedding / Sealant

    So on my 1989 Chaparral Fisherman 224, there are 2 sections of the deck that are removable to get greater access to the hull, fuel tank, etc. I was thinking of removing one to get better access to replace the fuel filler and vent hoses. My question, what would I use to rebed those sections...
  10. mjf55

    1989 Yamaha Engine Cowl repair

    I have a 1989 Yamaha 175 outboard, and the cowl is showing raw fiberglass across the top. I ASSUME that is it severe sun damage to the gel coat. What would be the best way to repair ithe. I was thinking of sanding off the loose fibers, then applying multiple coats of poly. Maybe thickend it...
  11. mjf55

    Funny "TLC needed" boat ads on Craigslist.

    I'm not sure this qualifies as TLC because I cannot tell, but this is some fantastic picture. here is the ad http://eastnc.craigslist.org/boa/5598427603.html
  12. mjf55

    Spindle sleeve replacement

    I am starting to restore my 1989 EZ Loader roller trailer, so I wanted to see if the axles are ok. I pulled the wheels and bearings and saw some wear on what I believe to be the spindle sleeve. It is the polished area near the square mounting (brake flange ?). I have a few questions about it...
  13. mjf55

    Links to other forums

    I wanted to answer a question a question on restoring gel coat and the answer was already in a forum on another site. I wanted to post a direct link to that site but was concerned that I would violate rule 6 or another rule. Is posting like that allowed? I will include the exact link here, as a...
Top