Search results

  1. Y

    Looking at a few different boat options - Opinions welcome

    Re: Looking at a few different boat options - Opinions welcome Point taken. Here is the new Option 2 1989 Celebrity 199 BR 4.3L Mercruiser, 4K
  2. Y

    Looking at a few different boat options - Opinions welcome

    Hi, I'm looking at a few different boats and wondered if you all could chime in. Option 1 1986 Chris Craft 196 Professional BR 4.3L Mercruiser Alpha 1. 4K Option 2 1988 Celebrity Crownline Cuddy 21 3.7L Mercruiser, 4K Option 3 1989 Rinker Captiva Cuddy 205 4.3L Mercruiser, 5K Boat...
  3. Y

    1994 OMC 115 Powerhead

    Hi Guys, I was out last night, kids were tubing, shut the boat down after motoring for about 15-20 minutes from ramp to clean water. Boat became hard to start, as in 10 minutes of start idle rough then die. did this a couple of times. This boat has been out 5-6 times this year and has run...
  4. Y

    Force 125 1985 prop nut is backing out

    I need some help. Motor was running great 2 days ago. Today I head out and only half power at wot in forward. Reverse s?ems to rev just fine. Put the boat back on the lift and looking at the prop the nut seems to have backed itself out. I also found a small Allen head cap screw wedged in the...
  5. Y

    115 V4 OMC + Turbojet Cold Starting issues, Four Winns Fling

    Not sure if this is the right forum, It is a Outboard powerhead attached to a turbojet inboard Jetboat. Here are the issues: Anyone have a good method for coldstarting this engine. Owner's manual says to "Depress the warm up knob". I'm not sure where this is or if it even exists. My normal...
  6. Y

    Cold Starting issue OMC 115 + Turbojet on a Four Winns Fling

    Not Sure if this is the right Forum, Thought I would Try: Anyone have a good method for coldstarting this engine. Owner's manual says to "Depress the warm up knob". I'm not sure where this is or if it even exists. My normal startup method is with the boat tied to the dock: 1. turn blower on...
  7. Y

    Four Winns Fling - OMC 115 Turbojet - Cold Start Issues

    Anyone have a good method for coldstarting this engine. Owner's manual says to "Depress the warm up knob". I'm not sure where this is or if it even exists. My normal startup method is with the boat tied to the dock: 1. turn blower on (wait) 2. turn key to position 1 to prime the carbs with...
  8. Y

    1972 Johnson 4 hp vs. 1966 Evinrude 3 hp best option same price

    Any advice on these would be appreciated. I know about Mercury's but not much on Johnson evinrude.
  9. Y

    1985 Force 125

    I am looking for a replacement lower unit complete (best case) or a replacement output shaft (worst case). Any help would be appreciated. Thanks Matt
Top