Search results

  1. T

    ghosting of old vinyl stickers?

    How do I remove the shadows of old registration numbers? And the weathered windshield rubber at base of window? thanks for any info.
  2. T

    ? on thermostat replacement?

    I bought a thermostat replacement kit for my 89 90 hp evinrude. My ?? is do I need to use any permetex sealant on any of the gaskets provided in the kit? Do I just reassemble and tighten? What about the 2 rubber hoses on the ends. Should i use sealent there too?
  3. T

    92 15hp johnson no spark? Kill switch?

    Motor has been sitting 10 yrs in family basement.now no spark, any ideas? And why is there a zip tie on kill button on tiller handle? Rope start.
  4. T

    9.9 spark plug problem

    pulled the plugs and found very different conditions on plugs. gaps are the same but dont look like proper combustion. any ideas on where to start. carb has been rebuilt and compression is also not the same in the cylinders. 90psi and 140psi. do i have a rebuild project this winter? This is a...
  5. T

    9.9 2000 4 stroke charge question

    so connect red and purple leads to battery. fuse the purple with what size fuse? It seems that regulator /rectifier is putting out 24v dc will that damage battery?
  6. T

    9.9 2000 4 stroke charge question

    this is just rope start no ignition or tach gauge. With the stator that I have would buying the non reg rectifier work then? another pic try
  7. T

    9.9 2000 4 stroke charge question

    I have a 2000 rope start, tiller handle model e10r4sse it did not come with electric start. I have measured voltage from a plug that comes out from under flywheel and I get 70v ac at idle and increases when revs up.there yellow wires and from 1 wire to ground its around 30 v and other is 28v and...
  8. T

    2000 9.9 four stroke compression?

    what is the right compression reading s for this motor. Im getting 155 and 125 the plugs for 155 psi looks black and loaded up? ill try to post pic.
  9. T

    do I need new rings? pics

    motor was running rough after warming up,so pulled plugs and found this. there not the same,is there an issue with the on cyclinder? these are from a 2000 9.9 4 stroke.I have had problems with what seems like a fuel problem( starts to struggle for fuel) pump ball and comes back up but not for long.
  10. T

    problem with tilt trim motor? with pics

    I have a 89 90hp evinrude with power tt the motor is making low groaning noises and working intermitenly . no leaks and fluid is ok. I think it might need a motor replacement any help in that process would be great thanks.
  11. T

    test pix post

    test
  12. T

    how to post with pictures??

    just need the steps to post pics, having trouble with the size of the pic I think?
  13. T

    warning horn ???? 19.5 gls 1989

    89 gls with 90hp evinrude. I need to know if this horn is supposed to "beep" when key is turned to run ---just prior to start, it does alarm when grounding temp sensor, so the horn does work.
  14. T

    Need another warning horn?

    Need help finding another warning horn. I think the one I have is defective. 89 Sea nymph with 1989 90 horse rude.
  15. T

    no alarm beep prior to start? 89 90hp rude

    great forum,been searching for this answer but cant find one. here is my problem 89 sea nymph boat with 90hp and vro still working, that has 3 wires coming out of it. 2 overheat sensors in the head that has 1 each.I should have a beep with key in run position, prior to start but I don't. I did...
  16. T

    in line fuse and boat fuse panel?

    replaceing fuse panel under dashboard of my metal fish boat. factory wireing is in good shape,the add on fish finder, cig liter,marine radio from previous owners all have a fuse at the panel and then an inline fuse also do I need them ? all of these have the same fuse size. the grounding "bus"...
  17. T

    trim switch?

    my tracker boat has a trim tilt switch in the throttle lever,up on the side of the hull I need a new one and cant find just the switch. they all com with the whole handle assy. can anyone help me get back on the water?
  18. T

    9.9 4stroke fuel issue

    9.9 drains bulb while i am trolling, I keep priming bulb and runs fine for a couple minutes. I switched bulbs from my 90hp and it drains that one too line are good and fuel screen is clean took cowl off and it runs alot better. any ideas where to start.???????
  19. T

    test post

    ...
  20. T

    nautolex vinyl sticking problem

    I put vinyl down on the new wood deck in my boat. the "toe kick ' portion of the deck where it is vertical is metal. the vinyl starts to peel up around the edges,I used the adhesive from nautolex for the floor but on the "toe kick" part used spray adhesive. How can I secure this vertical piece...
Top