Search results

  1. H

    1997 48hp evinrude starter problem

    when pull back to neutral starter engages, what to look for?
  2. H

    tach trouble

    1983 115 evinrude, tack works fine until i get over 4500 rpm. then it pegs right. if this is a short where should i look for it?
  3. H

    115 1983 evinrude

    you guys are the best and i would like to thank the forum for helping w/ all my problems w/ this engin. its running fine , just dont know if the carbs are synced. looks like one of the butterflies closes a little more than the other at idel, is this correct or should they both look the same?
  4. H

    trash and some water in floor tank

    i think i found my whole problem with to sluggish running sometimes. drained the tank and put 6 gals. of fresh gas, ran great till i slowed. drained the water seperator and found some small pieces of trash and some more water. can anyone tell me the best way to flush the tank out completly?
  5. H

    hard to start

    ok, here it is. finally got to go and run the boat. ran great,but slowed down and idled down a bayou for a 1/4" of a mile, put in neutral, and it killed. started bak up and ran to the mouthto fish. when started to leave could start with acceleration, but when i go to neutral it kills and took a...
  6. H

    1983 115 hp lower unit leak

    what would cause a small trickle of oil to run out of the small hole at bottom right side of lower unit?help!
  7. H

    had bogging down problem

    drained all the gas from floor tank, changed plugs and did a de-carb, checked fire w/ inline tester, cleaned carbs and got new gas, only 3 gal. in 6 gal. tank. did not have time to run on the step, but did back in at landing and nosed against the dock and opened her up. held 4200 r.p.m for 10...
  8. H

    compression

    what is the recommended range on a 1983 115 evinrude
  9. H

    compression

    i have a E 115 TLCTE evinrude 1983 . it has 92 psi on 1 , 112 psi on 1 and 117 on the other 2. is this ok or do i need a ring job on the one. the motor ran good until i found water in thefuel.
  10. H

    selinoid primer

    have broken *** on one of the small hose conectors on primer, does this affect the idel and do i need a new one. what does the silenoid do? its a 1983 115 tlcte . idels rough and bogs at high speed!
Top