Search results

  1. J

    65 evinrude 9.5 hp starter rewind prob

    Hi all, I'm having a problem with my starter rewind. If the two mounting screws are tightened all the way down it will not rewind. If I loosen them it rewinds. Pretty sure they are supposed to be tight because the water flow gasket undernieth. Am I supposed to lubricate something? Do I...
  2. J

    Shift Lever Adjustment

    Hi All, Is there a trick to getting the shift lever adjustment right? this is a 1965 9.5 hp evinrude sportwin. I had to undo the linkage to change out the impeller,and every since, the shift lever has been down a couple inches and it pops out of gear in forward if I go any faster than...
  3. J

    65 Evinrude 9.5 starter outer bearing

    Hi All, This place has been a wealth of information and helped me to get an old engine thats been sitting for more than a decade running like a top. the only problem I am having, at the moment, is that the starter cord wont rewind. I pulled the starter and disassembled it. The outer bearing...
  4. J

    65 9.5hp Evinrude, starter rope wont rewind

    Hi All, the starter rope on my 1965 9.5 hp evinrude sportwin wont rewind. It rewinds maybe one or two turns, but to get it rewound enough to pull again I have to take the lid off and wind it manualy. Even then the I can only rewind it four turns or so before the tension of the spring starts...
  5. J

    1965 9.5hp sportwin wont run without choke

    Hi all, Well, I rebuilt the carb and did a tune up. The engine finally starts, but I cant get it to stay running without the choke. I started with the slow speed needle at 1 and a half turns out and it would run for a few minutes with the choke fully out. I adjusted it in 1/8 and it wouldnt...
  6. J

    Oil in Barrel

    Hi All, This may be a dumb question, but it has been bothering me. I recently rebuilt the carb, did a full tune up and changed out the Impeller on my 1965 evinrude 9.5hp out board. I ran it in a 30 gallon container the other day. It was running for about 3-5 minutes. The question is, when I...
  7. J

    1965 Evinrude 9.5 hp sportwin impeller

    Hello, I have a 9.5hp 1965 evinrude. I pulled the lower unit off to check the water pump because there was no water pumping through the exhaust. What I found was an impeller in about 10 pieces in the housing. I ordered sierra part number 18-3003 to replace it. I got this part number from...
  8. J

    1965 evinrude 9.5hp sportwin carb rebuild???

    Hi all, I've been searching through the posts in this forum for an answer to my problem. I have a 1965 evinrude 9.5 hp sportwin motor that I am in the process of rebuilding the carb on. I have bought a couple repair manuals and I am at a loss. The slow speed needle in both manuals shows a...
Top