Search results

  1. M

    2 Problems with my 1961 Merc., 6 hp

    #1- When at idle it pees pretty well and the water temp is luke warm. As I up the rpms the water appears less and seems to get pretty warm (almost hot). Water is also coming out at the hole under the engine cover on the right hand side facing the engine on high rpms. If I have to replace the...
  2. M

    '61' Merc 6 HP Very Little Pee at High RPMs

    #1- 1961 Mercury 60. When at idle it pees pretty well and the water temp is luke warm. As I up the rpms the water appears less and seems to get pretty warm (almost hot). Water is also coming out at the hole under the engine cover on the right hand side facing the engine on high rpms. If I...
  3. M

    Adding Hydralic Fluid

    On my '78 Galaxy 120 Mercrusier, when I hit the buttons on the power trim, I hear the motor hummin but no action on the back end. I have followed the hydralic lines to see where the filler may be for the fluid, but I can't find the thang. Should I be looking for something that looks like a...
  4. M

    Water Squirting In Engine Compartment

    This is a '78 Galaxie with a 120 Mercruiser which is spewing water in the very back by the transom in the engine compartment with the mickey ears. It only does it when the engine is running. It increases with the rpm and it is about the size of a large diameter pencil. I can see it, but can't...
  5. M

    1978 Galaxy 18' Newbie

    Well, thanks for taking the time to look at my post. I have a guy that is selling a 78 Galaxy 18' with a mercruiser 120. It has been sitting in Michigan for about 2 years and not run. It seem to start without much trouble. The floors seem solid no tears in the white seats. Let it run for...
  6. M

    68 Evinrude No Spark From Distributor

    Is there anyway to test the distributor and rotor to find out if they are too worn? I have good spark up to the wire going into the distributor, but nothing going out to the plugs. I have cleaned all the brass areas and checked for cracks etc. but is there any other test that I can do to see if...
  7. M

    68 Evinrude distributor/rotor

    Is there anyway to test the distributor and rotor to find out if they are too worn? I have good spark up to the wire going into the distributor, but nothing going out to the plugs. I have cleaned all the brass areas and checked for cracks etc. but is there any other test that I can do to see...
  8. M

    68 evinrude magneto problem

    This motor ran fine 2 years ago, but now I had a problem with the amp, so I replaced it with a auto coil, etc. and now I have spark all the way up to the magneto. I mean I can take the plug wire that goes into the magneto and I get a good healthy spark, but I am not getting anything to the...
Top