Search results

  1. J

    evinrude trolling motor prop

    I'm in desperate need of a prop for an older trolling motor, the part number is 115827 or could be 0115827, it is a 2 blade plastic prop that is held on with a cotter pin. My motor is running great but the prop broke and I sure would like to find a good used one. It is 8.75 inches x 3.85?
  2. J

    Ignition switch left on

    I have a 2006 Sun Chaser pontoon, my question is if I turn the key on to use my accessories does it harm anything in the ignition system? I don't have an accessory on the key switch just the on then the far right to crank the engine over. I remember the older cars ( going back a few years ) it...
  3. J

    motor angle on pontoon

    I'm trying to figure out if the motor is at the right angle when it is in the water. The pictures here are with the boating setting on the trailer, is it down too far or is this where it should be when in the water? When I put it in the water how do I know where it should in relationship to the...
  4. J

    12volt starting battery

    Started to go out in the boat but starting battery was dead, I put the charger on it for a few minutes and got it to start. Took the boat out and ran it across the lake for a bit and brought it back, plugged the charger into it and it showed 13.2 volts but only 57 % charged. Left it on for a few...
  5. J

    2006 Yahmaha 50 TLR model 6H5KL-1008850

    I was on the water running about 3'4 throttle when all of a sudden I get this bad vibration in the motor and the speed dropped. Stopped & checked prop nothing tangled in it. Started back up and will idle to about 1500-200 rpm then the vibrating starts again. Got it back to the dock put one new...
  6. J

    repairing a seam on boat seat

    I have a pontoon with a sun deck to lay on, on the end of the cushion it has came apart at the seam but there is no way to remove it and sew it. I was wondering if there is a glue or something on the market that I could put on the part of the seam that has come apart to keep it from ripping the...
  7. J

    rubber seal on bottom cowl & oil leak 2006 Yahama 50TLR

    I noticed I do not have the rubber seal on the back end of the bottom cowl. What is the purpose of this seal? I also noticed I'm leaking oil before it mixes with the fuel. I cannot see a leak any where but when it set for awhile and I take the top cover off I see a very small amount of oil...
  8. J

    fuel cap for smoker craft sunchaser pontoon

    I'm trying to find a replacement fuel cap for a 2006 Sunchaser pontoon, it has a built in vent on the backside of the cap and I'm thinking that sometimes it is not opening after setting awhile. I get gas leaking out of the motor cover and only when it sets for a while and not necessary every time.
  9. J

    gas leak when sitting

    Went down to the boat 2006 Yamaha 50 hp 2 stroke today and when I started climbing in and out of it I noticed gas dripping onto the water. It hasn't ran for about 3 days and the temps and been in the 60's and 50's at night. I spent 30 minutes looking for a leak and could not find one anywhere...
  10. J

    2006 Yamaha 50 Primestart swtich

    I have a 06 50hp Yamaha that is hard to start when cold. I squeez the bulb a few times, hold the choke in for a couple of seconds and it's still takes a while to start. I know I have a Prime switch and it is in the correct position, today when I first started it I flipped it clockwise 1 turn to...
  11. J

    what gauge wire for starting 25hp motor

    I want to place my battery in the middle of my boat ( for weight reasons) and need to run a cable from the battery to the motor. What is a safe gauge wire to use for running about 8-10 ft. The only thing the battery will be used for is to crank over the engine.
  12. J

    evinrude trolling motor removal

    I have an older evinrude trolling motor and need to replace the wiring running through the shaft, how do i remove the motor from the shaft to be able to pull out the old wiring, all there is is a set screw but I cannot figure out how the motor comes off the shaft?
  13. J

    vinyl protectant

    live in florida and am having problem with mold on my seats when the cover is on. Is there anything I can apply to the seats to help keep mold and stains from growing. I can leave the cover off but then I have the hot sun baking my seats, carpet, rods and everything else plus the bird crap. Any...
  14. J

    06 sunchaser pontoon steering wheel removal

    I have a 06 Sunchaser Pontoon and want to replace the steering wheel, it says above the wheel on the console "safe-t steering, Ihave removed the nut but cannot get the wheel to slide off, any ideas on what is keeping it from coming off?
  15. J

    fuel filter on yamaha 50 2 stroke

    I think i found a fuel filter on my yamaha but not sure if it is one that has to be replaced or taken out and cleaned. I cannot find a video on this motor so can someone please let me know before I try to take it out. Also is there a filter inside of the 20gal fuel tank that needs maintained? Is...
  16. J

    new transducer on tube

    I'm thinking of installing my new depth finder on my starboard tube,I would like to go deeper in the water than what I had before, does anyone see any reason what I have temporary rigged up here not to work? The transducer would set about 4 inches lower than the bottom of the tube or do I need...
  17. J

    Removing mold/mildew from vinyl seats

    What is a good product that will remove mold/mildew from my pontoon seats? We tried the Roll Off which is a fantastic cleaner but did not do a lot with our seats. any ideas?
  18. J

    storage under seat vents

    Need some input on this topic, I have had issues with things stored under my seats getting mold or mildew on them, life jackets, hats, etc. I notice one toon where I'm at that had small vents in each of the compartments, about 4x4 inch. Would installing these in the front of each of the...
  19. J

    dual battery charging

    I want to be able to charge my starting battery and my trolling battery at the same time. What would I need to accomplish this? I've heard of tying the 2 batteries together but isn't then making a 24 volt charge going into the items I have attached.Thanks
  20. J

    solar battery charger

    Need some input on using a solar battery charger for my trolling motor. Talked to a couple of people and they feel a solar charger is worthless. Just now ask a man about his and he tells me that is all he uses, he says he has kept 2 batteries charged for the past year on nothing but his solar...
Top