Search results

  1. C

    1985 9.9 evinrude misfire

    did you replace/swap plug wires themselves. what resistance do you see plug boots to engine frame ground . do you see steady resistance value if you flex the wires while measuring
  2. C

    Engine not starting

    btw post your engine model # AA....AK ????? see back page on START NO FIRE T360 https://drive.google.com/drive/folders/1-0ZDC6uzVsBgE4MyEr7HVIyEJJcwXfn0
  3. C

    Engine not starting

    first.... the trim thing....if not a sticky trim button the relay contacts may have developped corrosion from arcing over time and...and are now sticking closed.... hence the trim motor not stopping. nothing to do with engine starts. starting or not... ETECs don't like loose connections...
  4. C

    Fuel appears to be inside of my Evinrude E-TEC Engine Management Module (EMM)

    no beep indicates absence of Key on power usually ... check all connections check for blown fuse think about getting the software EV diagnostic to see fault codes in the EMM . here is an article on the subject which all ETEC owners should get familiar with because ETEC service...
  5. C

    Fuel appears to be inside of my Evinrude E-TEC Engine Management Module (EMM)

    if you don't have it.... download your manual from this site pick the one closest to your model year https://drive.google.com/drive/folders/1-pyBmXzRaZ16y9sJ1QkSfjnBGwA-HzsB
  6. C

    Fuel appears to be inside of my Evinrude E-TEC Engine Management Module (EMM)

  7. C

    Fuel appears to be inside of my Evinrude E-TEC Engine Management Module (EMM)

    only water cooling is circulated inside a EMM then out he rear end . how did you determine fuel was inside your EMM unless contaminated water was sucked up and circulated in the whole cooling system. what is your engine mdl#... what is ...will not start ? does it crank and not...
  8. C

    Stalling at Idle and Idle Speed

    not certain but I think VRO can be serviced check utubes... check pulse line
  9. C

    Stalling at Idle and Idle Speed

    OP said fuel pump was "tested... by EV mechanic". symptom still indicates possible bad pump if " hand pumping" steadies the engine !
  10. C

    Stalling at Idle and Idle Speed

    engine mdl # ????
  11. C

    2014 Evinrude KNOCKING sound

    I noticed there is oddly some oil on/in the inside of the air intake box seems strange .... just my humble opinion...ETEC oil is directly injected inside the engine and none in the fuel for your model (early ETEC had "oil in fuel injection" but stopped around 2008) faulty reed valve...
  12. C

    Johnson Outboard Motor MODEL NO J30PL4SD 4 Stroke 30Hps Stalls after 20 minute use, then restarts after waiting 5 minutes

    restarting after a 5 min. period would seem to indicate some form of fuel flow problem impacted by poor venting and a vacum build up that eventually clears out. the alternative imho would be an electrical component fault caused by a high temperature intolerance eventually cleared...
  13. C

    2013 Etec Steering Question

    anything ETEC can be asked on the ETEC board... what does Can you tell me ehst the title is? mean....
  14. C

    2013 Etec Steering Question

    see answer on the ETEC board...
  15. C

    2013 Etec Steering Question

    download 2012 book from this iste ... it may help https://drive.google.com/drive/folders/1-pyBmXzRaZ16y9sJ1QkSfjnBGwA-HzsB
  16. C

    1974 9.9 Johnson running problems. I can get it started but then runs very ruff.

    if sparks ok sounds like crud ending up in the carb... maybe just a bad grey hose plugged tank pick-up, venting etc... sometimes badly stored engines end up with dried out fuel and running them years later loosens all that " varnish" and plugs the carb. time to take it apart.
  17. C

    Recoil spring spun in housing

    make certain rope lenght is per specs
  18. C

    Johnson Outboard Motor MODEL NO J30PL4SD 4 Stroke 30Hps Stalls after 20 minute use, then restarts after waiting 5 minutes

    if not fuel flow related try cooling down any suspect component to see if the restart time shortens.
  19. C

    No spark on half the motor!

    https://maxrules.com/graphics/omc/wiring/82_83_V6.jpg swapping cd units maybe a qwick easy test . melting coils doesn't sound good
  20. C

    Gale 7.5hp Montgomery Ward Sea King

    see post #2
Top