Search results

  1. Dukedog

    Water temperature coming out of the pee hole now what I'll do here

    unless it is an EFI or XR6 its gonna be a 2.0 motor.....
  2. Dukedog

    Water temperature coming out of the pee hole now what I'll do here

    t-stats open around 140ish ta 150ish.. good water pressure?.. no over temp alarm, then wouldn't think twice 'about it.............
  3. Dukedog

    Mercury V6 fuel flow from all carbs

    this............... and new gaskets are a must no mater how good old ones look..
  4. Dukedog

    Stator?

    send me an email addy and i will send ya an oem manual (in pdf) that will have your motor in it....
  5. Dukedog

    Mercury Black Max Problems

    when you say "cleaned" tha carbs did you use same gaskets or replace ALL gaskets with new ones?.. no mater how/what tha carb gaskets (inside and out) look like they need to be replaced with new when carb is disassembled for any reason...... jan.. all wh series (whats on your motor) carb gaskets...
  6. Dukedog

    1988 SeaRay Seville 135HP

    thats shifter linkage.. send me an email addy and i'll send ya manual.. its for different motors but they all work 'bout tha same.. parts are still called same names.. work same as your parts.. about tha only things that won't apply ta your motor are tha test value numbers on several (mostly...
  7. Dukedog

    1988 SeaRay Seville 135HP

    tha speedy pick up is a small hole in tha leading edge of tha gear case.. tha tube should go down inside tha steerin' arm.. it is tha over temp sensor wire but can't tell if its tha part that originates at tha sensor or if its tha part commin' from tha harness?.. either way they need ta be...
  8. Dukedog

    1988 SeaRay Seville 135HP

    if tha wire you are indicating is a tan/blue tracer with an eyelet is gonna be for over heat alarm.. its either tha one from tha harness or its from tha sensor on tha starboard head?
  9. Dukedog

    1988 SeaRay Seville 135HP

    tha tube by tha linkage is either for water pressure gauge or speedometer.. cant see colot of tha wire ya holdin'?.. looks like a brass plug under tha starter?.. can't tell for sure.. remote oil tank isn't that big.. maybe a gallon or two and doesn't have any wiring to it.. need picture of port...
  10. Dukedog

    1988 SeaRay Seville 135HP

    that looks like it could be tha hose that would pressurize tha oil tank in tha boat? is there a "plugged" hole right below tha starter?.. might be justa capped off fitting and/or a pipe plug?.. does it still have tha oil tank in tha boat?
  11. Dukedog

    Mercury Black Max Problems

    jus start this?.. always been "hard ta start"? when its cold and/or anytime? can be a number of things.. enrichner workin'?.. have you changed/altered linkage any?.. timin' any?.. alarm is over heat.. probably time for a pump "kit"..
  12. Dukedog

    2004 merc xr6 low water pressure

    check poppet.. how old is pump assy.?
  13. Dukedog

    1999 merc 200 efi 2 stroke no spark

    sent.. disconnect tha black/yellow on each of tha switch boxes.. check wires for continuity (should be none) ta ground ta be sure its workin'.
  14. Dukedog

    1999 merc 200 efi 2 stroke no spark

    first thing ta check is if tha kill switch is pulled?.. pre-mix in aux. tank?.. motor settin' up that long (old fuel?) may/may not have a long laundry list of things that can be problematic... send me an email addy and i'll send ya an OEM manual in pdf.. ya gonna need it...
  15. Dukedog

    1998 Merc 150 Stiff Steering

    with steering all tha way ta port can ya pull tha cables out of tha tubes without havin' ta pull motor?
  16. Dukedog

    1999 90 hp 3 cylinder 2 stroke mercury no power, sounds fine

    never mind me.. misread tha year.. its a cdm motor... sorry.
  17. Dukedog

    1999 90 hp 3 cylinder 2 stroke mercury no power, sounds fine

    no tach?.. think (not positive with tha "little" motors) it should have a stator with a high side and low side.. when high side gives up tha motor will act as normal (starts fine, idles fine, no grunts, groans, funny noises, misses, runs smooth) jus will not turn over 'bout 3 grand no mater how...
  18. Dukedog

    1999 90 hp 3 cylinder 2 stroke mercury no power, sounds fine

    when you say "half throttle" do you mean position of throttle? what are tha rpms? do you mean tha throttle is all tha way foward but its only moving at what is normally 1/2 "throttle"?.. need ta know what tha rpms readings are when its maxed out with throttle at wfo?
  19. Dukedog

    1998 Mercury 225 slipping at high speeds

    agree, probably set up.. boat type, motor (3.0 or 2.5 PM), offset, height, prop? i always liked a little "wiggle" at times.. kept me on my toes and payin' attention!
  20. Dukedog

    Mariner 175 V6

    stamped BUILD date... look on tha block.. just to tha right of tha block half flange at tha base of number 2 cylinder.. will be kinda right behind tha "bend" in tha timin' arm in tha picture.. m/d/yr in 1/8 inch numbers.. might be hard ta see but it is there.
View older results
Top