Search results

  1. D

    8.7 Volts at the Coil

    Is the ignition module properly grounded?
  2. D

    Sea ray sundeck 240 won’t rev passed 2000rpm

    How old is the fuel?
  3. D

    Knocking sound - what is it? [video]

    I don't know if it's the video frame resolution or me but the power steering belt appears to be loose. And the pump itself seems to be moving?
  4. D

    4.3 L cobra outdrive

    All cobras (non-king) will bolt up to any cobra bell housing The real question is are the gear ratios the same?
  5. D

    No spark then undid coil wires now weak spark

    Did you set dwell?
  6. D

    gimbal bearing house hit by trailer while emergent braking before red light.

    Could be excess grease pushed out after years of adding to the steering shaft upper bearing cavity
  7. D

    Mercruiser 4.3 l 190 inboard outboard will not start after installing new battery changing a fuel filter and changing oil up

    Is there spark? Fuel present in the carburetor?
  8. D

    Volvo Penta 5.0 GXI-E - Won't roll over

    Most likely the top cap seal. The large round rubber piece with the little side seal located at about 2 o'clock in the photo
  9. D

    Transom leak near exhaust

    Based on the photos, video and things you've sealed up I'd say it's time to pull the motor and remove the transom assembly Probably gonna find a lot of rot in the lower portion of the transom hole and most likely corrosion at the lower mounting studs
  10. D

    2009 Larson Cabrio 260 Electrical Issues

    The only way you'll have 110v AC power on board is connected to shore power, utilize a generator or have an inverter with a dedicated battery bank I think you ought to contact the seller and have them show you how to use the inverter if the boat is so equipped. Otherwise a seasoned boat...
  11. D

    1988 Searay 250 - Throttle: Fix or replace?

    The remote assembly itself may need cleaning/lubrication Not horrible to remove the assembly. Pop the plastic cover off the top and it ought to be held in place on the helm by four screws, possible through bolted Once out remove the plastic cover and inspect. If you decide to remove the cables...
  12. D

    Wet Exhaust Hose 90deg part

    No clue where to find it especially considering a Supreme dealer gave you the cold shoulder I'd find a 90 degree fiberglass tube same diameter as the exhaust and stub on two straight pieces of exhaust hose/tube to fit
  13. D

    3.0L MerCruiser, idle trouble.

    1100 is too high an rpm for idle speed in neutral. You want around 750ish in neutral, 650ish in gear on the water What is the idle timing set at? Carb looks way aftermarket, unsure if I'd have confidence it is of sound quality
  14. D

    1988 Searay 250 - Throttle: Fix or replace?

    The binnacle mount remote pictured is a nice one. I've run into little issues with the single engine controllers of that style You can try lubricating the cables but most likely they need replaced With the cables disconnected from the engine end does the controller handle move smoothly? When...
  15. D

    My boat run slowly. 120HP,2.5L,1989

    I do not Possible that was a reason for poor runnability Based on the other pics of cap, rotor, points, etc I'd say OP is due for a full tune up
  16. D

    My boat run slowly. 120HP,2.5L,1989

    First two plugs are the same, third is different When was the last full tune up?
  17. D

    replacing the inner prop shaft seal on bravo 3

    In order to properly remove/install the seals the propshafts need to be on a bench. I use a small slide hammer to remove the seals. Too risky with damaging the carrier housing cavity with a seal puller You will need the special tools to do this job correctly
  18. D

    replacing the inner prop shaft seal on bravo 3

    Can replace both propshaft seals without removing the drive from the boat I prefer doing the seals this way, helps support the drive for the removal/install of the retainer and carrier requiring high torque Once the job is done then remove the drive for pressure test, lube fill and transom...
  19. D

    Cracked Mercruiser 165 block

    Thats a shame Gm inline 6 is a wonderful motor. Based on how clean the package appears in the (fuzzy) pics it might be worth sourcing a different long block
  20. D

    gimbal bearing house hit by trailer while emergent braking before red light.

    Broken before the trailer was connected to the rig
Top