Well update. While the OB was in the full down position I applied 12 volts separately to each electric trim motor wires (removed them from the relays) and the green drives the motor as well as the blue but neither raises or lowers the motor. The motor continues to run non stop but not pumping...
How to manually raise motor that wont trim up (not trying to remove motor off transom). Exterior trim rocker switch on motor will only work on "down position". Checked the exterior rocker switch in "up" and "down" mode and both trim relays/wiring and all check in good in power up and power down...
Thanks. The rod shaft with the golf like end OD diameter looks to be close to the ID diameter of the tube its in. I hope I can pull it out from the bottom once the lower unit is removed. I've had 3 of these DT140's 20" shafts (this is the 1st DT 140 fuel injected one) over the past 30 years. I...
How to remove the upper long clutch rod from the engine once the top and bottom ends are disconnected. Seems it can't come out from the top due to the intake casing in way. So if the lower unit is removed will the long rod "slide" out of the bottom from the casing where the rod is in the tubular...
Look the dt140 2001 model as the 97-2000 model "have " an electric pump in addition to the mechanical pump! look it up at brownspoint.
Yes there is...look it up. Did you know the 97-2001 motors have an electric fuel pump as well as a mechanical one. That number is for the electric pump.
Ok seems there are no threads on the forum regarding Suzuki efi low pressure electric pumps for DT115 or DT140 outboards except the oem ones. Has anyone used the after market USA hi performance pump model 15100-94900. Appears to be the same specs as the oem one. If so any problem with the pump...
I just checked in on the forum today and seen your reply. Very glad you responded with diagrams. But They are not clear enough.....meaning lines and letters blurred. Could you try sending them again...maybe they will show up in a sharper image. I also zoom at the down low and makes it fuzzier
Thanks
What harness connector and or oil injection points to disconnect the oil injection from motor. Going to mix oil and in gas tank. Disconnecting oil injection to see if it is causing an intermediate shut down of motor at times. thanks
looking for a quality meter to use to check all the coils and associated items readings as the engine is "operating"... output side.
I have the old school analog meters ( Simpson/ Tripett) that do an accurate job on static readings of coils, sensors. etc. And a Fluke clamp on digital meter.
I...
