Recent content by EFisher

  1. E

    Vortec engine or not?

    Thanks for the info, Fun Times!
  2. E

    Vortec engine or not?

    Just wondering if my engine is a Vortec or not. Engine Ser.# OF142713. 4 bolts each connecting exhaust to heads. Thanks.
  3. E

    Still working on 4 Bbl 9600 weber carb problems on Mercruiser 4.3lx. Advise please!

    achris, you the man brother. Just when hope was waining! Picked up a new sensor/switch and she's running like a Swiss watch. Can't think you enough. Love the input from fellow boaters on this forum!
  4. E

    Still working on 4 Bbl 9600 weber carb problems on Mercruiser 4.3lx. Advise please!

    I calibrated float drop and level on both floats with new gasket on and installed rest of the rebuild kit per, #18 manual reassembly; dialed in accelerator pump and choke pul off linkages. Set the idle mix screws to 1 1/4 out from seat. Throttle linkage off. NOTE, Only one side of fuel injector...
  5. E

    How to install choke linkage rod from 4Bbl weber 9600 into 4.3lx manifold?

    Sorry for bothering you all. After looking more closely I found the loop at the end of the spring.
  6. E

    How to install choke linkage rod from 4Bbl weber 9600 into 4.3lx manifold?

    It didn't specify in the #18 manual.
  7. E

    How to install choke linkage rod from 4Bbl weber 9600 into 4.3lx manifold?

    When I pulled carb off manifold I didn't notice how the choke linkage rod attached to the manifold. Now need advise to reinstall the rod. Thank you.
  8. E

    Maxim 2000sc 4.3lx 4Bbl carburetor question

    Great! Love the knowledge base in this forum! Thanks!
  9. E

    Maxim 2000sc 4.3lx 4Bbl carburetor question

    Awesome! Now I just need to know if the Carter has the same bolt pattern at base as the Weber.
  10. E

    Maxim 2000sc 4.3lx 4Bbl carburetor question

    So, the service manual does not give the spec for CFM for the Weber carb. I have an opportunity to buy a remanufactured Carter 9600 Marine carb-600 CFM. I hear that Weber/Carter/Eldebrook are clones. True? Anyone know if CFM is the same for the Weber 9600? Reason for wanting to purchase is that...
  11. E

    Maxim 2000sc 4.3lx 4Bbl carburetor question

    Chris, thank you! Exactly what I needed. Greatly appreciated!
  12. E

    Maxim 2000sc 4.3lx 4Bbl carburetor question

    I have a 1994 Maxum 2000sc with the 4.3lx and 4 Bbl carb. Stalls after 10-20 seconds of op. Believe I need to rebuild the weber carb. Anyone know if there is a spec manual for this unit? Thanks!
  13. E

    1995 4.3 lx 4 barrel carb adjustment

    I have a 1994 Maxum 2000sc with the 4.3lx and 4 Bbl carb. Stalls after 10-20 seconds of op. Believe I need to rebuild the weber carb. Anyone know if there is a spec manual for this unit? Thanks!
  14. E

    1994 Maxum 2000sc hull draining

    Cutty and small ski locker box have drain holes whereas both compartments had standing water. I snaked them anticipating the snake to enter the bilge. It didn't, but went forever. Where does the water drain too? Apparently not into the bilge.
See more
Top