Recent content by Chuck4741444

The model number is not readable, i do have the numbers on the title, its an ox66

Fuel injection, the orings are for the electrical separator on to of the vapor housing

Im replacing the high pressure fuel pump on the vapor separate, the pump is sitting 90 degrees off to line up with the studs everything else fits. Also what are the molded pcs that slid over the studs on top called, I need the o rings, the didn't come with the kit.

I just bought this 98 evinrude 9.9 pull start, the gear that turns the flywheel is ground up (plastic) and doesn't drop down with out tapping it down, but it cut a grove in the flywheel.

I found the problem with rough I have plenty of for fire, I pulled each wire off one at a time running, stuck a screw driver in it and held close to ground . Jump 1 inch and sounds like LIGHTENING!!!!! the cause of the rough running was water in the fuel, I had water in it last year, so i...

The oil / fuel pump is deleted.

I did it, took it out to the lake and ran it hard, running great. I set the float to make the difference, if anyone ask you, be sure to tell it works just fine.

This motor has the oil deleted, it running pre mixed fuel.

I used them, set the floats, the float has plenty of travel up and down,

The hoes is an1/8 from the front lower of the crankcase. The floats were set, the carburetor comes off without disturbing the linkage , its all connected on the throttle plate.the throttle, Ill check the spark gap, And make sure coils are firing, the one thing I may have done is i used the...

I have a 1/8 vacuum line coming fron the crank case, I plugged it, I dont know where it should go. Could the electric primer be letting fuel through it? The did have the purple white wire disconnected, i added a plug and reconnected it, it doest can the rough running either connected or...

Motor new to me, it running rough, I have rebuild carbs, clean the holes in the throttle plate, stars and runs easy. I have sprayed carb cleaner on the carbs, throttle plate and the intake manifold. Crank case seal, check for loss fuel lines, I cant find an air leak, I pulled the plugs and...

Im rebuilding a set of carbs, the old needle set doesn't have the white seal, but the kit includes it. I just readjusted the float. Does it matter as long as the is set?

The top bolts are 3/8 to close that 3/16 each side. I built a rack to hold the old motor today, I believe the bolts with have enough slack, I can split the difference between the new bottom holes and the top. Thanks guys, I believe i was over thinking it. I just didn't want to drill and plug...

Thanks. Ill file them larger.