Recent content by Chrisham

  1. C

    1962 evinrude fatwin 18hp carb settings.

    I set points at 20 but ordered a coil gap tool and an ignition timing tool so I can get it right
  2. C

    1962 evinrude fatwin 18hp carb settings.

    I don't see any cracks in the coils.One coil does look newer.I sanded the contacts with 150 grit and sprayed carb cleaner.I don't know enough about points to tell if they were good are not.I gaped them at 20.Do I need to replace the condensers?Do I need to lightly sand the flywheel contacts on...
  3. C

    1962 evinrude fatwin 18hp carb settings.

    I don't see any cracks in the coils.One coil does look newer.I sanded the contacts with 150 grit and sprayed carb cleaner.I don't know enough about points to tell if they were good are not.I gaped them at 20.Do I need to replace the condensers?Do I need to lightly sand the flywheel contacts on...
  4. C

    1962 evinrude fatwin 18hp carb settings.

  5. C

    1962 evinrude fatwin 18hp carb settings.

    112 both cylinders
  6. C

    1962 evinrude fatwin 18hp carb settings.

    112 both cylinders
  7. C

    1962 evinrude fatwin 18hp carb settings.

    What is the best way to get the flywheel off.I know it usually requires a special tool.will screwdrivers and a maiiet work.Do you have to take the 4 screws off holding the plate on top of the flywheel
  8. C

    1962 evinrude fatwin 18hp carb settings.

    The carb looked good inside no varnish or crud .I got a kit anyway
  9. C

    1962 evinrude fatwin 18hp carb settings.

    I ment to say the foot oil had no water in it
  10. C

    1962 evinrude fatwin 18hp carb settings.

    You are right I was looking at the choke knob.I had a brain fart
  11. C

    1962 evinrude fatwin 18hp carb settings.

    I usually buy a factory omc manuel but 1965 was the earliest I found.
  12. C

    1962 evinrude fatwin 18hp carb settings.

    I just got it at an estate sale saturday.I have no clue.Its a nice looking motor.I have the foot off changing the impeller.I pressurized it and it held 12lbs for 30 minutes .The foot grease had no oil in it.The fuel lines were hard and I do not imagine it has run in a very long time.I poured atf...
  13. C

    1962 evinrude fatwin 18hp carb settings.

    The high ,low and other jet
  14. C

    1962 evinrude fastwinn 18 hp.Which fuel line goes to the pump?The one close to the block or the ot

    No arrows that I saw
  15. C

    1976 456hh 45 hp.magneto model

    Sorry for the late reply .I finally got some new coils as mercury made some.I relaced both and the Ole 45 is running great thanks everyone for the help
See more
Top