grizzreaper
Petty Officer 2nd Class
- Joined
- Oct 8, 2007
- Messages
- 160
Ok I been looking all over .I have tried different sites and Google.i took a donor block and took my valve cover, flywheel, carb,manifold, rear engine mount,coupler, fuel pump and igntion coil. Going to pull my cap and rotor next.i tried wiring it up but it just won't turn over.i have power to starter and if I jump the starter it will turn over. now I have the original wire harness and I have taken a 12 volt battery n checked each wire. It goes #1 black ground, #2 is gray wire and spliced twice, #3 is a brown wire, no #4 wire but there is a hole, #5 is a purple wire spliced 4 times, #6 big red wire with a purple/black stripe and spliced three times, #7 is a yellow wire with a red stripe, #8 is a light blue wire, and #10 is a black wire with a white stripe with plastic block screwed into. Sorry for the long post but I want to put the motor back in but I want to make sure it's good to go. Thanks in advance.posted a couple of pics with serial numbers on valve cover.