Vintage outboard repair help?

[Robojoko]

I am restoring a 1956 Evinrude Lark engine. It is running and on first run gives indication of a spun hub; runs and moves fine at lower rpm. As I raise rpm's the boat goes still. I need help locating a replacement hub. I am new to vintage boats, but really want to learn. Any help would be appreciated. Regards.

 

[Robojoko]

I am restoring a 1956 Evinrude Lark engine. It is running and on first run gives indication of a spun hub; runs and moves fine at lower rpm. As I raise rpm's the boat goes still. I need help locating a replacement hub. I am new to vintage boats, but really want to learn. Any help would be appreciated. Regards.

 

[F_R]

Send it to a prop shop, either locally or find one on-line. OR, buy a new prop. Hardly anybody attempts to fix those things themselves.

 

[Baylinerchuck]

I am restoring a 1956 Evinrude Lark engine. It is running and on first run gives indication of a spun hub; runs and moves fine at lower rpm. As I raise rpm's the boat goes still. I need help locating a replacement hub. I am new to vintage boats, but really want to learn. Any help would be appreciated. Regards.

Not sure if you already posted, but you might want to ask your question in the Johnson/Evinrude outboard section of the forum. You’ll get a much better response over there.
Chuck.

 

[jbcurt00]

Moved & merged

 

[saltchuckmatt]

Not sure if you already posted, but you might want to ask your question in the Johnson/Evinrude outboard section of the forum. You’ll get a much better response over there.
Chuck.

This is the Johnson/Evinrude forum.

 

[jbcurt00]

This is the Johnson/Evinrude forum.

Was double posted in 2 forums, the J/E forum and another, moved and merged over an hour before you commented.

@Robojoko don't post duplicate topics on the same subject.

 

[Robojoko]

Thank for the clarification. Sorry for my confusion.