ranger481vs
Petty Officer 2nd Class
- Joined
- Aug 5, 2019
- Messages
- 104
I just removed my sea water pump to replace the impeller. First time doing this, in general. I have a couple of questions. My housing is metal. The rings on the inside look machined to me, but just want to make sure there's no visible issues with the housing before reassembly.
Also, the seal behind the pulley isn't seated correctly. You can see the snap ring, but based on the parts diagram, there should be a tolerance ring, which I could not see. I could use some advice on repairing this correctly. Thanks!
Also, the seal behind the pulley isn't seated correctly. You can see the snap ring, but based on the parts diagram, there should be a tolerance ring, which I could not see. I could use some advice on repairing this correctly. Thanks!