Hi. Helping a friend with his yamaha. On a yamaha 115 salt water 1996. To replace the water pump gasket. How to take off the plate? Do i need to take out the shaft collard? How.
Thanks
Got that, thanks. This is the picture after taken out the impeller (in pieces) What does not make sense is that the part marked with an X was inside the impeller. How do i get it into the new impeller? (grease, force...?) I do not see this part (X) in the break down.
wait a minute... you need to take off the collar and spacers to get that off.
remove parts 21, 18, 19, 20, 19.
to remove part 21, tap with a chisel upwards. take note of the order of spacers.
do a forum search here, I have posted the complete,step by step,bolt by bolt procedure.
its for a V4 but all V4 and V6 two strokes from 95 to about 2005 used the same procedure.
at least it will help keep you from asking how to get out the impeller drive key