In my never ending saga of problems with this pos setup i now can't get the shifting mechanism adjusted such that the drive will go into forward and reverse.
I followed all the instructions in the factory manual but there isn't enough travel in the master shift cable to get the drive to go into both gears. I can get reverse only if i take the lower cable off and pull it the last inch by hand.
What am i looking at here? Bad cable or bad parts inside the drive itself? The shifting foot feels a little bit wiggly if i try and move it but i have no clue if its enough to cause the issue im describing.
sure wish i had gone with an outboard setup.....
I followed all the instructions in the factory manual but there isn't enough travel in the master shift cable to get the drive to go into both gears. I can get reverse only if i take the lower cable off and pull it the last inch by hand.
What am i looking at here? Bad cable or bad parts inside the drive itself? The shifting foot feels a little bit wiggly if i try and move it but i have no clue if its enough to cause the issue im describing.
sure wish i had gone with an outboard setup.....