Lund Pro V 1775

[kep1662]

If I take the screws out of the center section will the floor come out or is there something else I have to do? I just bought a 1995 and am probably going to have a lot of questions. And what is the best way to get rounded out screw heads? Also is there anywhere I can get a book on this boat? 1995 Pro V SE

 

[jasoutside]

Re: Lund Pro V 1775

Howdy kep and welcome to iboats!

If you grab some photos of what you are working on and head over here...

Boat Restoration, Building, and Hull Repair

...waaaaayyyyy better than any book you could get your hands on!:thumb:

 

[jigngrub]

Re: Lund Pro V 1775

Pics are a must for the best advice.

Rounded of screws are best drilled out if countersunk, panheads can be removed with vice-grips sometimes.

Do you plan to replace the decking?

 

[kep1662]

Re: Lund Pro V 1775

Pics are a must for the best advice.

Rounded of screws are best drilled out if countersunk, panheads can be removed with vice-grips sometimes.

Do you plan to replace the decking?

No,the floor is fine. I used a Grabit and it worked fine. Do I have to take off the back deck to get the floor board out. I'm just trying to trace out the battery charger wires because it went bad.