lower crankshaft seal removal

harley 1028

Cadet
Thread starter
Joined
May 9, 2018
Messages
20
Wish I would have know that to begin with .I'm not sure the seal was leaking just got scared of it when I saw the spring off all the pics I saw on line of the part - the seal wasn't protruding past the case.Anyway I did get it off had to remove the 4 center bold and tapped 2 of the holes with 5/16x 18 tap then flat piece of metal drilled 2 holes and against the center pulled right off working very slowly tighten each one then the other it came off will pick up new seal tomorrow from dealer now the fun will be getting it all back together thanks for everyone's help
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
You can usually just push the new seal in with your thumbs. Depends on how deep you push it in as to how far the lips protrude out of the case. Get you some long screws to get that thing back in there. All thread studs would be best. Look at the cap. It has a drain hole in the side & the block has a corresponding hole. Be sure those line up. Grease the orings & go slow. Hope things go well.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Bolt holes are drilled so that housing will only go one way !
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
That is true racerone, but he is only going to get a shot at getting it in straight & lined up from a long way out! Just wanted him to know how it goes. The oil hole is the best way to get a reference since he won't be turning it like you do when building a powerhead. I can't wait to see how this turns out.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
To get the housing back in, he can put some threaded rods in two or three of the eight holes, and use nuts to pull the housing in a bit at a time.
 
Top