I have a 1969 evinrude 115983E... It ran fine forever, staring with just a tap of the key. Boat is near showroom condition, some old people owned it, and the some of the bolts still have the factory paint from torqing bolts down. The only thing I did to it was replace the wires for the primary coils under the flywheel when i first got it because of small amounts of green death.
One day i took it to the lake and wouldnt start. I changed the plugs and it would run ruff at idle and better at higher speed. I took it home then no start.
I have blue spark from plug to ground..plenty of fuel.. checked the diaphram, connections, coil seems fine.
I looked at a thread of how to test the amplifier, thinking electrical. It said to test the wire on the busy bar Purple/black for 12v with the key on. With the key on and meter set to volts dc, the reading is 0.1 volts. I tested it while turning the motor over and it went up to 8.3v.
Am I on the right path here? Stator? Dist? pick-up? I am completely baffled and need help to figure out my next step. I am the middle of working on it right now and would love an immediate response.
One day i took it to the lake and wouldnt start. I changed the plugs and it would run ruff at idle and better at higher speed. I took it home then no start.
I have blue spark from plug to ground..plenty of fuel.. checked the diaphram, connections, coil seems fine.
I looked at a thread of how to test the amplifier, thinking electrical. It said to test the wire on the busy bar Purple/black for 12v with the key on. With the key on and meter set to volts dc, the reading is 0.1 volts. I tested it while turning the motor over and it went up to 8.3v.
Am I on the right path here? Stator? Dist? pick-up? I am completely baffled and need help to figure out my next step. I am the middle of working on it right now and would love an immediate response.