Tommyaleks
Seaman Apprentice
Thread starter- Joined
- Mar 10, 2017
- Messages
- 33
Hi guy`s. I hope someone can help me with a problem. Evinrude 1995 40 hp no vro. The problem is. the engine runs wherry fine on idle no issue at all but when I start to give it some rpm it runs bad, I have no clean or full rpm, it`s like when something is blocking or to much oil in the fuel. I have done a service on the carburettor`s and they are fine. The floaters are correct adjusted and needle/ seat are fine too. The mixture screws are about 2 1/2 turns out from the bottom. I also have checked the valve under the carburettor, I can blow in both ends of it. so I think it`s fine. Don`t know exact what that valve is or do so if anyone know please let me know. So my next step was to check the fuel pump and I found 1 thing I`m not sure of is correct. it is 3 hoses on the fuelpump, 1 goes to the tree/carburettor`s and 1 goes to the valve and 1 comes from the fuel tank. back of the fuel pump there is a small hole that fits on the small hole on the engine block. but the hole on the engine block was blocked with a screw. it was a little loose and it came a little fuel out of the hole when I screw the screw out. My question is, Shall that screw be there? I can`t figure out why the engine runs so bad on high rpm, and it`s smoking some too.
I hope someone can help.


I hope someone can help.




