FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Removed lower unit and replaced now I'm blowing a 20amp fuse. It has the hydraulic electric shift motor is 115 Johnson v4 please help I heard u guys where good people and helpful
Re: A Little help please keep blowing 20 amp ignition fuse
Lol yes would work.........I did think of pinch wire I tore lower unit apart again and checked but I didn't see any pinched wires. I reassembled careful and did same thing I'm baffled could I have ruined seleniods?
Re: A Little help please keep blowing 20 amp ignition fuse
There is no way you would have ruined the solenoids unless you took the cover off them. Did you? Anyway, the way to find out is use a multimeter to do a resistance check on the blue and green wires. Testing is so much easier than guessing.
Re: A Little help please keep blowing 20 amp ignition fuse
Well the plastic cap between the coward and reverse seleniod was loose in between there does that matter I didn't touch and what about the wavy washer that goes on top of the two does this need to be positioned right?
