Re: 1987 evinrude 150 trim problem
As soon as it gets on top of the water i start trying to trim it up to steady the boat from bouncing. the trim comes all the way up but there is no angle within the 15 degrees that it will trim the boat out. just stops at the top of the 15 degrees as it should. i just dont understand why i cant seem to trim out as in 3 years of running this boat, i have never had this problem. always popped up and trimmed right out, no problem.
Larry... Your last post indicates that in the past 3 years, this engine being on the same boat, it has performed as it should pertaining to the tilt/trim unit....... meaning that this same engine, tilt/trim unit, boat combination could be trimmed out to a degree whereas you obtained a normal plane (angle of attack).
This bouncing... I assume you're not speaking of a high rate of speed in rough water. Any rig is going to bounce in rough water. I picture in my mind a condition we call purposing.
If this was a case of transferring the engine over to a different boat... a boat that might have a different angle of attack (bevel) to the transom, I could understand the problem. This would bring up a case where one would need to install adaptors/shims between the transom brackets of the engine and the transom to modify the angle of attack of the engine.... something you may still need to do. The shims are a accessory, needed for various boats so rest assured that they can be purchased at your dealership or a marine type store.
Starting from scratch, engine in water or not, makes no difference, BUT engine NOT running. Engine trimmed all the way down. Observe engine and press the trim up button... notice the rpms of the PTT motor and the speed of which the engine is rising. At the 15 degree mark, the sound/rpm changes and the engine starts to raise more quickly. Okay, that gives one a good idea of the trim vs the tilt position and function. What will hold and what won't.
If, as per the immediate above paragraph, the PTT unit functions as it should, having the 15 degree trim movement, then going into the tilt movement, and NOT losing pressure in the trim area while underway.... the problem would need to be with the boat, not the engine, and this is normally due to being trailered or set up on blocks (stored) incorrectly which leads into forcing the hull to develop a hook.
Looking at the hull bottom from a side angle, a hook of the hull can usually be easily observed.... the front of the hull goes back normally for a distance, then raises a bit as one looks towards the transom, then lowers back down (the hook) to its normal depth as it nears the transom. This causes the boat to plow, bow down, and if fast enough, to become air borne only to plow down and continue the cycle.
If no hook exists, and hopefully it does not, and the 15 degree travel of the PTT is holding as it should, has anything been done to the engine or boat that could possibly result in the rig moving faster... becoming air borne? At any rate, something has changed and it seems to me that the cure is to have the shims installed in order to have a greater amount of upward trim movement.
Hopefully this has been of some help to you.