Hello, so I just picked up a 1978 imperial 16' Trihull for very cheap. Obviously because of the age and the price I've got a good amount of work to do. Fortunately the Johnson 115 that came on it seams to run great, at least out of the water on muffs it runs great. I've torn up the deck and started ripping out the slightly water logged foam. So now I'm getting ready to start on repairing the stringers. I have one variable on this boat right now, the transom has been repaired before. The repair was done without separating the top and bottom and not very much cutting on the back, it consists of new wood ( about half as tall as the factory wood would have been, doesn't go all the way down but the wood is very solid) and aluminum plate that covers the entire outside of the stern, another aluminum plate on the inside of the stern so the wood is basically sandwiched between the two plates and there is a third small plate on the upper inside of the stern. Does this sound like a decent transom fix, it feels very solid, with the motor up I can grab the bottom by the prop and lift up and down very hard and there is zero flex in anything on the stern. Seems good to me I just would like some input from some more experienced boat repairers. The wood not going all the way down is the only worry I have, not sure what I'm worried about but I am. Any input from you guys would be greatly appreciated and I'll try and get pictures posted