TheRedDragon
Cadet
Thread starter- Joined
- Jul 6, 2016
- Messages
- 23
I am a novice in the boating world that picked up a free 14' forester trihull from my father in law. It was covered but in the elements for a number of years, and then garaged for periods of time. We got the 1972 Johnson 40HP to fire and run on the second try, so it has it's good points. Like many of you would expect, the floor has some soft spots. I have read the forums for weeks trying to learn what I can about the floor/stringer structure and the process of replacing it.
I'm ultimately looking for a simple fishing boat on small lakes that my wife, daughter and I can enjoy. I haven't pulled up the floor at this point, but was wondering if anyone had any experience with this specific style/model of boat and could provide a little information on the sub floor structure. I can feel no give in the center beam, or the beams that appear to run front to back along the very sides of the hull. The two areas that on either side of that main beam do have some give.
Today I found a post about the use of foam in trihull floor structure for support between beams. Is that typical? What is going on down there?
Hopefully these will help give an idea of what she looks like



Thank you in advance for your time and advice.
I'm ultimately looking for a simple fishing boat on small lakes that my wife, daughter and I can enjoy. I haven't pulled up the floor at this point, but was wondering if anyone had any experience with this specific style/model of boat and could provide a little information on the sub floor structure. I can feel no give in the center beam, or the beams that appear to run front to back along the very sides of the hull. The two areas that on either side of that main beam do have some give.
Today I found a post about the use of foam in trihull floor structure for support between beams. Is that typical? What is going on down there?
Hopefully these will help give an idea of what she looks like



Thank you in advance for your time and advice.