Re: 1960 Glastron FireFlite has a new home!
Spent some time w/ a grinder in the FireFlite after work tonight. Forgot to talc up, it's been awhile, numb-skulled it

Also removed about 80 screw cap snaps. Then moved on to removing a little of the rubrail!

Only had 1 bind up & snap the bolt, and 1 that wouldn't break loose, and had to be cut. I'll need to replace a few of the bolts I removed, they were damaged during the uncovering stage
Unscrewed & removed starboard rear sections, about a large 1/4 of the total:
The last bolt on the far left of this rear area is where I had to cut a bolt.
Found a little bit of the original 'gold' vinyl that was behiind the Glastron script in the ellipse between the upper & lower rubrail sections at the stern:
I think this:
is an acceptable alternative, and will work with some of the Merc decals from the guy in NY. I still need to figure out how to best remove (reuse??) the flat clip thats pushed down & partially under glass to remove the Glastron script & a few of the other bits & pieces faux screwed to the hull.
The good new is that once I get the rubrail & a few other things out of the way, it's clear sailing to grind the hull/cap joint. There are very few SS screws holding the cap to the hull, and it will easily be lifted after grinding the interior seam covering glass.
It was good to get some time to work on her. Even if only for a bit. Had to make sure she knew I wouldn't ignore her...
Good luck getting over the hump tomorrow & towards the weekend!