The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a 2005 Johnson 2 stroke engine. My diagnostic led display will sometimes cycle while running the boat. The led go through the cycle and I get a single beep which is same as when I first turn on the key. What is a good way to troubleshoot this problem. It is very intermittent.
I occasionally experience the main 20 amp fuse blow when I start the engine. This does not happen very often but when it occurs the engine has been run several hours with several restarts to move to other fishing areas. Does anyone have a schematic of this circuit? It looks like the starter...
I have a 2005 Johnson outboard with carbs. Engine runs great at higher rpms. I am have trouble running at trolling speeds after the engine warms up. What is a good troubleshooting procedure? Engine will stall at idle after warm up but still runs great at higher rpms.
After running the engine for a short period. I'll shut it down to fish and then restart it. It stalls out several times before I can get it to run without stalling. When running along at cruising speeds it runs perfect. What should I do to troubleshoot this problem? I plan to drain gas and put...
Where is the adjustment to lower the idle speed on a Johnson 2005 90 HP located? Do I adjust the throttle cable or is there a separate idle adjustment screw?
I've got a Johnson 2005 90HP. There are two cables entering the engine. It is difficult to see which cable is the shift cable. Is the top cable and trunnion for the shift?
I have the following
90 HP Johnson 2 stroke engine
17 1/2 foot center console (fiberglass)
Prop is 13.25 x 17 with 3 blades
Lowest trolling speed (at idle) is 4 mph
I would like to troll below 2 mph
What prop is recommended without causing damage to engine at higher RPMs?
We boat is on trailer with garden hose attached I can shift in and out of gear with no problem and cannot duplicate the problem. When boat is on the water and I shift out of gear I must go a little past the shift detent point to get it to come out of gear. I can't understand why it shifts...
I have a problem coming out of gear and going into neutral. The boat is a center console and when I shift into neutral there is not a positive out of gear detent or stop. Is this a simple adjustment? I brought it to a dealer and he sat on boat for two weeks before he adjusted cables. He said it...
Engine starts up fine. Runs perfect at top end. Sometimes it will stall out during idle speed. I can watch the tach go down and sometimes prevent stall by pushing the key in. What is a good troubleshooting approach to identify the problem?
Engines starts fine and idles fine. When I rev up the engine in driveway on hose it is fine. Problem occurs on water when in gear and try to throttle up. It then stalls out. It will start up fine and idle fine but stalls when idling up in gear. Gas is from last year and I'm not sure how long...
I just purchased a Johnson 2005 90 HP engine. My question is about the primer solenoid lever that needs to been moved when fogging the engine. I have the small manual that comes with engine. It shows the lever must be at 6:00 in order to start/run the engine and at 9:00 to fog it. My engine...
I just purchased a 2006 McKee Craft. Does anyone know how the washdown and livewell work on this boat? Do I need to add water with a pail or do the wells have a mode to draw water in? Also anywhere I can a operator's manual for this boat?
