Search results

  1. ‘

    ‘73 Bee Craft

    Ok great, thx.
  2. ‘

    ‘73 Bee Craft

    Do I use laminating or finishing resin?
  3. ‘

    ‘73 Bee Craft

    Yeah I thought about that too, extending the deck supports.
  4. ‘

    ‘73 Bee Craft

    I’ve got my measurements. Sketched to lay out. These stringer weren’t bedded really.
  5. ‘

    ‘73 Bee Craft

    No the was blocks of foam running down the center between the stringers. They were just resting in there. Saturated of course. I think I’ll do 2 part foam once I get there.
  6. ‘

    ‘73 Bee Craft

    Floor is completely out. Stringers still in place. For now. This is what it looks like. Idk what’s going on the the center stringer
  7. ‘

    ‘73 Bee Craft

    So I can bed without foam?
  8. ‘

    ‘73 Bee Craft

    So if I bedded the stringer in PB would that be good enough?
  9. ‘

    ‘73 Bee Craft

    Ok so I’m tackling the stringers this weekend. Tab in with CMS, then 1708 then CMS, and 1708 cap?!?!? Is the foam spacers between the hull and stringer a real thing. It seldom gets mentioned?!?!
  10. ‘

    1989 Chrysler Conqueror

  11. ‘

    1989 Chrysler Conqueror

    And one know anything about this boat. Gal wants $2k for it. It been in the garage for the past year.
  12. ‘

    ‘73 Bee Craft with Chrysler 70 o/b.

    I have this outboard. It’s a “Chrysler 70”. That’s what the cover says. I assume that means a 70 h/p? Well anyways. I can get it to turn over. But that’s it. Compression is at 92 psi on all three cylinders with good spark and new plugs. I got a new line with fresh gas. 50:1. Battery is new...
  13. ‘

    ‘73 Bee Craft

    Ok. I’ll check it out. New tank?
  14. ‘

    ‘73 Bee Craft

    I will. I’m trying to get the motor to run. I’ve built tables, remodeled bathrooms and landscaped yards. I’ve always been able to avoid small engine repair. Until now. I have good compression 92-94. I have good spark. I got a new tank and mixed up a gallon with 50:1. Nothing. I just it up with...
  15. ‘

    ‘73 Bee Craft

    Yes it has a cradle. I was hoping not to pull the cap. But I may have to pull it anyways.
  16. ‘

    ‘73 Bee Craft

    Did some exploration. This is what I’ve found. The “wood” on the bit came from a stringer you see I’ve drilled out. Supporting the hill. It’s currently on the trailer. How do I go about stabilizing it. Can I do one stringer at a time to minute disruption in the hill.
  17. ‘

    ‘73 Bee Craft

  18. ‘

    ‘73 Bee Craft

    Goof it off. And then I think I just want to roll some gel coat on the inside instead of carpet. Is that a thing? Any prep other than cleaning up the hull?
  19. ‘

    ‘73 Bee Craft

    So I can just goo
  20. ‘

    ‘73 Bee Craft

    1) thank you for your assistance. 2) what do you thing of this loctite marine PL.
Top