Search results

  1. S

    Reed Valves

    Have done all you mentiond. The brass fiitting with mesh screen on top is that where oil enters? can find no opening in fitting.
  2. S

    Reed Valves

  3. S

    Reed Valves

    Hi, I have a 1980 7.5 Johnson that has spark, compression and fuel but will not try to start. I have cleaned the carb. changed plugs and wires checked fuel pump to no avail as a last resort I removed the reed valves, shinning a flashlight behind reed valves I could see a very small amount of...
  4. S

    carburetor swap

    thanks for reply. I. will try to repair the 25 hp carb. & reinstall
  5. S

    carburetor swap

    I did swap carbs but cannot get it to idle or stop sneezing. Was that the reason you wouldn't recommend it?
  6. S

    carburetor swap

    Was asking if 20 hp carb could be put on a 25 hp motorÉ not other way round.
  7. S

    carburetor swap

  8. S

    carburetor swap

    I do have both carbs. I will change them over reaso being I want to keep the 25 hp it's electric start Would I have to change any jets?
  9. S

    carburetor swap

    Can you swap a carb. from a 25 1974 hp Johnson for a carb. from a 20 1975 hp Evinrude? Not concerned with speed or oower loss. Thanks.
  10. S

    johnson flywheel

    Thanks, I was thinking along those lines.
  11. S

    johnson flywheel

    Thanks for reply racerone. It's a 582437 (typo mistake) good to know it will work. Out of curiosity would you happen to know what the D number stands for.
  12. S

    johnson flywheel

  13. S

    johnson flywheel

    Can anyone tell me if a (not sure of year) #5882427 D2 flywheel could be used to replace a damaged one #582100 D1 off of a 1980 7.5 Johnson. Thank you.
  14. S

    Evenrude 20Hp ?

    I just also purchased a 20hp Evinrude made in Canada. Could not find any information on motor Apparently OMC U.S. did not make them after 1972 Member F R identiied it as a 1976 I also have a 1975 which he also idendtified some time ago they both share the same cowling decals not sure if that...
  15. S

    Evenrude 20Hp ?

  16. S

    magneto wiring

    I have acquired another 20 hp Evinrude made in Canada during the period they were no longer made in the USA. They don't have the OMC codes to identify any information i.e. year of manufacture parts numbers etc. Looking thru Iboats forums I was fortunate to come across a member having the same...
  17. S

    Ignition alarm

    As I previously mentioned horn works.
  18. S

    Ignition alarm

    Thanks for reply .As I understand the beep when you turn key to on is to verify all systems are working, I know one beep is heat alarm test but I'm not getting any sound. Wanted to know If I should be. Thanks for your time.
  19. S

    Ignition alarm

    I re-glued magnet to float (thanks to great videos posted on you tube.) Warning beep stopped when I reconnected wires but until I get the alarm working satisfactory I will also premix fuel and disconnect wires. You say you fill your oil tank when you fill fuel tank. .Does oil still get mixed...
  20. S

    Ignition alarm

    I have a 1996 ELPTO 30 HP. Have no sound when turning on ignition. I remember reading sometime ago that Mercury eliminated the beeping sound when ignition key turned on. Would appreciate if anyone could inform me if this is correct for my motor, before I try to remedy problem. I had oil tank...
Top