The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Re: Advice needed on material for major repairs
One is a pic of the stringer removed and the other is where I cut a small patch out to see what is up. It looks like where they came in and layed the stringers in, glassed them to the hull and it is not bonded to the hull in this section.
Re: Advice needed on material for major repairs
Getting ready to order the resin and glass and need alittleadvice, unsure what I really need. The glass on the stringer looks like all chopper gun CSM on this sea ray. The stringer has several curves to cover. so need a liile direction here . I...
Re: Advice needed on material for major repairs
Steve at US Comp. said since I am going to leave the old glass behind the ply that was removed, I should use an epoxy (the layer of glass that is really enclosing the foam section) and glue the ply to it with thickened epoxy, then use the VE and...
Working on a stringer repair and need some advice. The boat has issues the inboard engine stringer up thru the gas tank area. The engine stringer is wet and has dark samples from the very bottom. The end of the gas area that meets the engine stringer is shot. The plan was to replace the gas...
Do I really need to use Resiweld when replacing the lower swivel bushing on a alpha one gen 2 gimbal ring? If so, is there something else I can use.........really cost a ton for this stuff. Thanks
I have a friend that inherited a 2004 Sea Ray 280 that has been stored outside on a trailer its whole life. In the last year the boat was stored off center with the starboard side lower than the port, with the bottom drain plug left in and the bilge held water for some time.
The transom moisture...
